Desa CGN10L, CGN6L installation manual Installing Two Mounting Screws, Folding Anchor

Page 11

INSTALLING TO

Installing Two Mounting Screws

Note: Wall anchors and mounting screws are in hardware package. The hardware

WALL

package is provided with heater.

Continued Attaching to wall stud method

 

For attaching mounting screw to wall stud

 

1.

Drill hole at marked location using 9/64" drill bit.

 

2.

Insert mounting screw into wall stud.

 

3.

Tighten screw until 1/16" space (thickness of penny) is between screwhead and

 

 

wall.

Attaching to wall anchor method

Follow instructions below to attach mounting screws to hollow walls (wall areas between studs) or solid walls (concrete or masonry).

1.Drill holes at marked locations using 5/16" drill bit. For solid walls (concrete or masonry), drill at least 1 1/4" deep.

2.Fold wall anchor (see Figure 6).

3.Insert wall anchor (wings first) into hole. Tap anchor flush to wall.

Figure 6 - Folding Anchor

4.For thin walls (1/2" or less), insert red key into wall anchor. Push red key to “pop” open anchor wings (see Figure 7). IMPORTANT: Do not hammer key! For thick walls (over 1/2" thick) or solid walls, do not pop open wings.

5.Tighten two screws until 1/16" space (thickness of penny) is between screwheads and wall (see Figure 8).

Thin Walls

(1/4" to 1/2" thick)

Figure 7 - Popping Open Anchor Wings For Thin Walls

Thin or Thick Wall (thick wall shown)

1/16" Space

Solid Wall

ANCHOR

Figure 8 - Tightening Anchors

Continued 11

103546

Image 11
Contents What to do if YOU Smell GAS OWNER’S Operation and Installation ManualSafety Information Contents001 Piezo Ignition System Local Codes Unpacking Product FeaturesSafety Device Product IdentificationProviding Adequate Ventilation Fresh AIR ForCombustion VentilationDetermining if You Have a Confined or Unconfined Space Fresh AIR for Combustion and VentilationDetermining FRESH-AIR Flow for Heater Location Ventilation Air From Inside Building Ventilation AIRVentilation Air from Outdoors Ventilation Air From OutdoorsLocating Heater Installing to WallInstallation Items Check GAS TypeMarking Screw Locations Installing Heater to WallFolding Anchor Installing Two Mounting ScrewsInstalling to Wall Connecting to GAS Supply Checking GAS ConnectingPressure Testing GAS Supply Piping System To GAS SupplyChecking Pressure Testing Heater GAS ConnectionsOperating Heater For Your Safety Read Before LightingOperating HeaterShutting Off Burner Only pilot stays lit Operating Heater Inspecting BurnerPilot Flame Pattern Shutting Off HeaterModel CGN6 will be lower due to lower input rating Burner Flame PatternODS/PILOT and Burner Orifice CleaningMaintenance Trouble ShootingTROUBLE- Shooting See CleaningObserved Possible Remedy Problem Cause Ing statement at If you smell gasShut off gas supply Do not try to light any applianceParts ServiceTechnical HintsValve GA5010 Service Publications AccessoryCentrals CGN10L CGN6L KEY Part Number for Description QTY CGN6L CGN10L Parts ListKeep this Warranty Warranty Information