Desa CDVBPC, CDVBNC installation manual REMOVING/REPLACING Glass Door, Installing Remote Receiver

STOVE AND DIRECT-VENT BURNER SYSTEM INSTALLATION

Installing Optional Wireless Hand-held Remote Control Accessories - CGHRC and CGHRCTA Series Removing/Replacing Glass Door

21

STOVE AND DIRECT-VENT BURNER SYSTEM INSTALLATION

Continued

INSTALLING OPTIONAL WIRELESS HAND- HELD REMOTE CONTROL ACCESSORIES - CGHRC AND CGHRCTA SERIES

Installing Remote Receiver

1.Open bottom door on stove body and locate the switch plate on the left of the valve bracket.

2.Unscrew switch plate (see Figure 44).

3.Disconnect wires from THTP and TH on control valve that lead to the switch (see Figure 45). Discard switch plate, screws, and nuts.

4.Install battery into receiver battery clip and connect to termi- nals (see Figure 46).

5.Place receiver into valve bracket and align holes (see Figure 47).

6.Use push-in fasteners included with receiver to secure to bracket.

7.Connect the wires from the receiver to the valve at TH and THTP (see Figure 45).

LO

H

I

OFF	I
	P
	L
ON	O
	T

Figure 47 - Installing Remote Receiver

Installing 9-Volt Battery in Hand-Held Remote Control Unit

1.Remove battery cover on back of remote control unit

2.Attach terminal wires to a 9-volt battery (not included). Place battery into the battery housing.

3.Replace battery cover onto remote control unit.

	Terminal		Remote
9-Volt		Battery Cover	Control
	Wires		Unit
Battery

LO

H

I

OFF	L
	P
	I
O	O
	T
N

Figure 44 - Removing Switch Plate

Battery Housing

Figure 48 - Installing Battery in Hand-Held Remote Control Unit

To Control

Switch or

Optional

Accessory

Figure 45 - Control Valve Terminals

Receiver

9-Volt	Terminal
Battery	Wires

Battery

Clip

REMOVING/REPLACING GLASS DOOR

You must remove glass door to install logs, lava rock, and ember material. To remove glass door, you must first remove the front panel on stove body.

CAUTION: Do not operate this burner system with a broken glass door panel or without the glass door panel securely in place. For replacement part infor- mation see Replacement Parts, page 36.

1.Remove 2 bolts from bottom of stove and one from the top of stove to remove front panel (see Figure 49, page 22).

2.Remove the screws from the 2 tabs at the top of the glass door while holding door securely keeping it from falling forward.

3.Grasp door by both sides and ease it upward off of the lower bracket (see Figure 50, page 22).

4.To replace glass door, follow the above instructions in reverse.

Figure 46 - Installing Battery in Receiver

For morevisit www..com

105501-01F