Desa CDVBPC, CDVBNC installation manual Installing DIRECT-VENT Burner System Into Stove Body

CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY

Stove Body Assembly (Cont.)

Installing Direct-Vent Burner System Into Stove Body

7

CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY

Continued

10.Attach stove door by inserting step bolt through door hinge pivot hole and into threaded hole in stove body (see Figures 9 and 10, page 6). Use an adjustable wrench or a 12mm socket to fasten step bolt. Tighten step bolt until snug. Make sure door moves freely.

11.Install door catch bolt (M8 x 1.25-55mm with two M8 hex nuts) into threaded hole on stove body (see Figure 9, page 6). Use an adjustable wrench or a 12mm socket. The catch bolt has two hex nuts attached to it (see Figure 13). The top nut is a bolt stop and the bottom nut is for door leveling adjustment.

12.Check general catch bolt alignment with door claw. Make fi- nal adjustment and door leveling after stove is in normal stand- ing position.

13.Carefully lift stove back up on its four attached legs.

14.Set top grate into stove top.

	Bolt Stop
Door Claw	Adjusting Nut
Door	Catch Bolt

Figure 13 - Catch Bolt and Door Claw Orientation

INSTALLING DIRECT-VENT BURNER SYSTEM INTO STOVE BODY

1.Carefully lift burner system and place into stove body from the rear of stove.

2.Using screws provided, attach burner system to back of stove.

Washers

Bottom Of

Stove Unit

Bolt

Stove Bottom

Figure 11 - Attaching Stove Bottom

Stove

Door

Door	Threaded
Hinge	Hole
Step Bolt	Stove Bottom
Bolt Shoulder

Screw

Burner

System

Cast Iron

Stove Body

O

P

Figure 14 - Installing Burner System Into Cast Iron Stove Body

Figure 12 - Attaching Stove Door

For morevisit www..com

105501-01F