22
STOVE AND
Removing/Replacing Glass Door (Cont.)
Installing Logs, Lava Rock and Glowing Embers
STOVE AND DIRECT-VENT BURNER SYSTEM INSTALLATION
Continued
Bolt
Bolt
4.Place log #3 (left piece) onto the front left part of the grate. Make sure it is seated properly over the prong of the grate as shown in Figure 53.
5.Place log #4 (right piece) onto the front right part of the grate making sure the notches fit over the prong of the grate (see Figure 54).
6.Place lava rock along sides and front of inside of burner system bottom. It is not necessary to use all of the lava rock provided.
NOTICE: Do not put lava rock on burner or under burner. Placing lava rock on burner could cause performance problems.
Stove Front Panel
Figure 49 - Removing Front Panel from Stove
1
Screw
2
Glass
Door
Figure 51 - Installing Log No. 1 Figure 52 - Installing Log No. 2
Figure 50 - Removing Glass Door from Burner System Insert
INSTALLING LOGS, LAVA ROCK AND GLOWING EMBERS
WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this burner system may result in property damage or personal injury.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with freestanding burner system. Do not use if any log(s) are broken (see Replacement Parts, page 36).
1.Remove glass door. See Removing/Replacing Glass Door, page 21.
2.Place log #1 (back log) on top of grate. Make sure the notches in the bottom of the log fit over the grate (see Figure 51).
3.Rest log #2 (large front log) on the pins on the front part of the grate (see Figure 52).
3 | 4 |
|
Figure 53 - Installing Log No. 3 Figure 54 - Installing Log No. 4
For
.
.com
