Desa VS24NRA, CFS18NRA, VS18NRA, VS30NRA installation manual Installing Logs

OWNER’S MANUAL

INSTALLATION

Continued

INSTALLING LOGS

WARNING: Failure to posi- tion the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in prop- erty damage or personal injury.

Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Place front log (#1) on top of the grate. Make sure the notches in the bottom of the log fits over the grate prongs (see Figure 16). Push back of log flush with metal grate bar.

2.Rest middle log (#2) behind metal posts on front burner. Make sure the grooves in the bottom of the log fit over the grate. Bring the log forward next to the metal posts. The cutout on the middle log must be on top (see Figure 17).

3.Slide the grooves in the back of the rear log (#3) against the rear grate prongs. Make sure the peg on the log is on top (see Figure 18).

4.Place the crossover log (#4) on the back log and the middle log. Make sure the peg on the rear log is in the hole in the bottom of the crossover log. The cross- over log should fit in the cutout of the middle log (see Figure 19).

	Front Log
Notch	(#1)

Grate

Prongs

Metal Grate Bar

Figure 16- Installing Front Log (#1)

Middle Log (#2)

Groove Groove

Metal Post

Grate

Figure 17 - Installing Middle Log (#2)

Groove	Peg
in Back	Rear Log (#3)
of Log	Groove
Grate	in Back
	of Log
Prong
Rear
Burner

Grate

Prong

Figure 18 - Installing Rear Log (#3)

Crossover

Log (#4)

		4	Hole
Cutout	4		Peg

Figure 19 - Installing Crossover Log (#4)

104416 13