Desa LSFG20NT Inspecting Heater, Operation, Manual Lighting Procedure, Pilot Flame Pattern

Page 14

Operating Heater

Continued

THERMOSTAT Control

OPERATION

The thermostatic control used on these models differs from standard thermostats. Standard thermostats simply turn on and off the burner. The thermostat used on this heater senses the room temperature. At times the room may exceed the set temperature. If so, the burner will shut off. The burner will cycle back on when room temperature drops below the set temperature. The control knob can be set to any heat level between 1 and 5. This adjusts the amount of gas flow to the burner that increases or decreases the burner flame height.

Note: The thermostat sensing bulb measures the temperature of air near the heater cabinet. This may not always agree with room tem- perature (depending on housing construction, installation location, room size, open air tem- peratures, etc.) Frequent use of your heater will let you determine your own comfort levels.

MANUAL LIGHTING

PROCEDURE

1.Remove front panel (see Figure 10, page 9).

2.Follow steps 1 through 7 under Lighting Instructions, page 13.

3.With control knob pressed in, strike match. Hold match to pilot until pilot lights.

4.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Now follow step 9, under Lighting Instructions, page 13.

5.Replace front panel.

Inspecting Heater

Check pilot flame pattern and burner flame pat- tern often.

PILOT FLAME PATTERN

Figure 18 shows a correct pilot flame pattern. Figure 19 shows an incorrect pilot flame pattern. The incor- rect pilot flame is not touching the thermocouple. This will cause the thermocouple to cool. When the thermocouple cools, the heater will shut down.

If pilot flame pattern is incorrect, as shown in Figure 19

•turn heater off (see To Turn Off Gas to Ap- pliance, page 13)

•see Troubleshooting, page 16

Note: The pilot flame on natural gas units will have a slight curve, but flame should be blue and have no yellow or orange color.

Thermocouple

Blue Pilot Flame

 

 

Pilot Burner

Figure 18 - Correct Pilot Flame Pattern

Thermocouple

Yellow Pilot Flame

Pilot Burner

Figure 19 - Incorrect Pilot Flame Pattern

BURNER FLAME PATTERN

WARNING: If yellow tipping occurs, your heater could pro- duce increased levels of carbon monoxide.

NOTICE: Do not mistake orange flames with yellow tipping. Dirt or other fine particles enter the heater and burn causing brief patches of orange flame.

14

www.desatech.com

116307-01C

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Garage Models ResidentialModels SF20NT, SF20PT Table of Contents Safety InformationSafety Information Local Codes Safety InformationProduct Features Product IdentificationDetermining FRESH-AIR Flow for Heater Location Air For Combustion VentilationProviding Adequate Ventilation Ventilation Air From Inside Building AIR for Combustion VentilationVentilation AIR Check GAS Type InstallationInstallation Items Ventilation Air From OutdoorsInstalling Heater to Wall Locating HeaterPlacing Heater On Mounting Screws Connecting to GAS SupplyMarking Screw Locations Locate hardware packet behind left side door of heaterNatural Gas Propane/LPTest Pressures Equal To or Less Than 1/2 Psig 3.5 kPa Pressure Testing Heater Gas ConnectionsChecking GAS Connections Open equipment shutoff valve see FigureOperating Heater For Your Safety Read Before LightingInstalling Refractory and Front Panel Shutting Off Heater Lighting InstructionsTo Turn OFF GAS To Appliance Shutting Off Burner Only pilot stays litOperation Manual Lighting ProcedureInspecting Heater Pilot Flame PatternBurner Pilot Air Inlet Cleaning MaintenanceODS/PILOT and Burner CabinetTroubleshooting Observed Problem Possible Cause RemedyTroubleshooting When heated, vapors from Turn heater off when using Noise when burner is litDirty or partially clogged Clean burner see Cleaning Turn off air supplyWhen Gas Pressure Is Too Low Technical ServiceService Publications Service Hints Gas leak. See WarningVSFG20NT VSGF20PT SpecificationsLSF20NT, LSFG20NT, VSF20NT LSF20PT, LSFG20PT, VSF20PT SF30NT SF30PTParts Central AccessoriesReplacement Parts Illustrated Parts Breakdown Parts List Warranty Information Keep this WarrantyModelos Para Cochera Consumidor Conserve este manual para referencias futurasModelos Tabla de contenido Información de seguridadInformación de seguridad Desempaque Códigos localesIdentificación del Producto Características del ProductoConstrucción inusualmente sellada Aire para combustión VentilaciónCómo Procurar LA Ventilación Adecuada Espacio confinado y no confinadoAire del interior de la construcción para Ventilación Aire Para Combustión VentilaciónAire Para Ventilación Artículos DE Instalación InstalaciónVerifique EL Tipo DE GAS De las partes anterior, superior Ubicación DEL CalentadorDonde cortinas, muebles, ropa Fuertes corrientes de aireColocación del calentador en los Tornillos de montaje Instalación DEL Calentador EN LA ParedDoble en anclaje de pared como se muestra en la figura Coloque el calentador en los tornillos de montajeConexión AL Suministro DE GAS Ventila apuntando hacia abajoRepare todas las fugas inmediatamente Revisión DE LAS Conexiones DE GASGas natural Instalación del panel anterior y el refractario Abra la válvula de cierre del equipo consulte la figuraInstale el panel anterior y el refractario Instale un difusor frontal como se muestra en la figuraFuncionamiento del Calentador Instrucciones DE EncendidoFuncionamiento DEL Inspección del CalentadorCómo Cerrar EL Suministro DE GAS AL Aparato Encendido ManualPatrón DE LA Llama DEL Calentador Inspección delLimpieza y Mantenimiento SF30NT EspecificacionesGabinete LSF30NT, VSF30NTSolución de problemas Causa Posible RemedioSolución DE Problemas Combustión El problema desapareceráLlama amarilla durante la No hay suficiente aire En el quemadorConsejos para servicio Servicio técnicoPublicaciones de servicio Al inicio de la páginaCentral de piezas AccesoriosPiezas de repuesto Válvula DE Cierre DEL Equipo GA5010Clasificación ilustrada de piezas Lista DE Piezas Información de garantía Guarde Esta Garantía

VSF30PT, LSFG20NT specifications

The Desa VSF30PT and LSFG20NT represent two significant innovations in the HVAC (Heating, Ventilation, and Air Conditioning) industry, catering to diverse consumer needs and preferences.

The Desa VSF30PT is a powerful and efficient forced-air heater designed for residential and light commercial applications. One of its primary features is its high-efficiency output, providing a substantial heating capacity while consuming minimal energy. The unit is equipped with a robust heat exchanger that enhances its performance, ensuring optimal heat distribution throughout the space. A notable characteristic of the VSF30PT is its user-friendly digital thermostat, allowing for precise temperature control, which can significantly improve comfort levels and reduce energy consumption.

Additionally, the Desa VSF30PT incorporates advanced safety features, such as automatic shut-off protection in case of overheating or airflow obstruction. Its compact design makes it easy to install in tight spaces, providing flexibility in placement without compromising on effectiveness. The unit operates quietly, minimizing noise disturbances, which is especially important in residential settings.

On the other hand, the LSFG20NT is an innovative gas furnace that combines performance with energy efficiency. This model is equipped with a variable-speed blower motor that allows for consistent airflow and improved humidity control, making it an excellent choice for homeowners who prioritize comfort. Its multi-stage heating design ensures that the furnace operates at different levels according to the heating demand, optimizing energy usage and enhancing overall efficiency.

The LSFG20NT also features a modulating gas valve, which adjusts the burner output to provide just the right amount of heat for any given situation. This not only improves comfort but also contributes to significant energy savings over time. Furthermore, the LSFG20NT is designed with advanced filtration systems that improve indoor air quality by trapping dust, allergens, and other particles.

Both units showcase the latest technology in HVAC systems, emphasizing energy efficiency, safety, and user convenience. With their unique features and characteristics, the Desa VSF30PT and LSFG20NT stand out in the market, making them ideal choices for those seeking reliable and efficient heating solutions. Whether for residential or light commercial applications, these models promise performance that meets the demands of modern-day heating needs.
Top Page Image Contents