Quadra-Fire QUADRA-FIRE CONTOUR warranty See Fig, Flex Hose, Hose Clamp Collar Assembly

Termination Cap with Rodent Screen

Hose Clamp

Contour Pellet Stove

Outside Air Kit Instructions

Part #811-0871

Parts Included in Kit: 1 piece of 2"x3' flex hose, 2 hose clamps, 1 collar assembly, 1 termination cap assembly, 1 trim ring, 12 screws (Discard air channel).

Tools Needed: Phillips Screwdriver; Wire Cutters; Hole Saw or Jig Saw.

The Contour Pellet Stove has 2 different mounting configurations on the back of the stove for installing the

Outside Air Kit. Identify which type you have and follow the appropriate instructions.

PRE-CUT HOLE in back of stove (Fig. 2), attach the Collar Assembly to outside of stove as shown in (Fig 3).

SQUARE COVER PLATE, (Fig 4) attach Collar Assembly inside stove as shown in (Fig 5).

Instructions:

1.Open left side panel to access the inside rear area of stove (Square Cover Plate only). Attach Collar Assembly.

See Fig. 5

2.Measure distance from floor to air vent opening in stove and mark location on wall.

Use saw to cut opening in wall. Cut a 2-1/2" to 3" opening on inside wall and a 3" to 3-1/2" opening on outside of house.

3. Use hose clamp to secure flex pipe to Collar Assembly.

4. Slide trim ring over flex pipe and run pipe through wall.

5.Attach hose to outside termination cap with second hose clamp.

6.Secure termination cap to outside surface.

7. Secure trim ring to interior wall.

Fig. 2 Fig. 3 Trim Ring

Fig. 1

Flex Hose

Fig. 4 Fig. 5

Snip corners and remove plate.

Hose Clamp

Collar Assembly

Attach Collar Assembly over hole.

October 10, 2001 21 250-5583