Quadra-Fire 4300 WOOD STOVE SERIES installation instructions Wood Stove Series

Page 1

R

4300 WOOD STOVE SERIES

Advanced Combustion Technology (ACT)

MILLENNIUM

STEP TOP UNI-BODY

Tested and

O-T L

Beaverton

Listed by

Oregon USA

C

OMNI-Test Laboratories, Inc.

VERY IMPORTANT!!

BEFORE STARTING YOUR

FIRST FIRE READ

HOW TO OPERATE THE 2-STEP DOOR HANDLE

ON PAGE 20

This manual contains instructions for Installation, Operation & Maintenance. Please read this entire manual before you install and use your new room heater. Failure to follow instructions may result in property damage, bodily injury, or even death.

IMPORTANT SAFETY NOTES:

1)When installing your stove, particular attention should be paid to fire protection. If this room heater is not properly installed, a house fire may result. To reduce the risk of fire, follow the installation instructions. Contact local building, fire officials or authority having jurisdiction about restrictions, installation inspection and permit requirements in your area.

2)CAUTION: Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid, or similar liquids to start or “freshen up” a fire in this heater. Keep all such liquids well away from the heater while it is in use.

3)During operation, if any part of the stove starts to glow, the stove is in an overfired condition. Close the air controls completely by pulling them out, until the glowing has stopped. OVERFIRING VOIDS YOUR WARRANTY!

4)Cool ashes should be disposed of carefully, using a metal container.

5)Do not burn wet or green wood. Store wood in a dry location.

6)DO NOT BURN GARBAGE OR FLAMMABLE FLUIDS SUCH AS GASOLINE, NAPHTHA OR ENGINE OIL. Do not burn treated wood, or wood with salt (driftwood, etc.). Burning materials other than wood (including charcoal) under adverse conditions may generate carbon monoxide in the home, resulting in illness or possible death.

7)Do not permit creosote or soot to accumulate excessively in the chimney or inside the firebox.

8)Check your chimney system thoroughly when installing into an existing metal or masonry chimney. Seek profes- sional advice if in doubt about its condition.

9)Do not connect this unit to a chimnney flue already serving another appliance.

10)Comply with all minimum clearances to combustibles as shown in this manual for this appliance.

11)Build fire on brick firebox floor. Do not use grates, andirons or other methods to support fuel.

12)HOT WHILE IN OPERATION! Keep children, pets, clothing and furniture away. Contact can cause skin burns.

13)Do not connect to any air distribution duct or system.

14)RISK OF FIRE! Do not operate with stove door or ash removal system door open.

15)For further information refer to NFPA 211 (USA) or CAN/CSA-B365 (Canada).

16)Do not operate without fully assembling all components. Burning your stove wthout the legs attached (if supplied with unit) will void your warranty, and could present a serious safety hazard.

17)Do not operate with broken glass.

PRIOR TO FIRST FIRE: Remove all labels from glass. Clean plated surfaces with a glass cleanser and soft cloth to

prevent staining from fingerprint oils.

1445 North Highway

SAVE THESE INSTRUCTIONS

 

 

 

Colville, WA 99114

Part 250-7061C December 10, 2004

www.quadrafire.com

Image 1
Contents Wood Stove Series ACT Wood Stove Series Table of Contents Installation Materials Needed for Safety Listings & Safety CautionsDimensions Step TOP UNI-BODY Pedestal Model Locating Your Stove Vent SpecificationsClearances to Combustibles UL and ULC USA -4300 Millinneum USA 4300 Uni-Body Step Top Floor ProtectionBoth Models USA Required Canada RecommendedAlternate Materials Worksheet ACT Wood Stove Series Floor Protection Cont’dChimney HEIGHT/DRAFT Masonry Chimney Cont’d Flue SystemsMasonry Chimney Solid Pack Chimney with Metal Supports AS a Thimble Masonry Interior Chimney Connection to a Metal PRE-FABRICATED ChimneyMobile Home Installation ARS Operating and Cleaning ASH Removal System ARS InstallationLEG Model Pedestal ModelLEG Model Pedestal or LEG KIT Installation Pedestal ModelMillennium Only TOP Heat Shield INSTALLATION, Part Installation of Optional BLOWER, PartAdjusting the Blower Speed CONTROL, if Necessary Part Outside AIR KIT InstallationAIR Controls Operating InstructionsBuilding a Fire ACT Wood Stove Series Operating Instructions Cont’dBurn Rates OpacityWood Selection and Storage Blower Operating InstructionsCreosote Chimney CleaningFirebrick Glass CareGlass Replacement Brick Replacement InstructionsPart Replace with 5mm ceramic glass only Baffle Removal and Installation Door Handle AssemblySpring Handle Warning Exploded Views DOOR, Glass and Door Handle AssemblyModel Shown Step Top Uni-Body Service Parts AccessoriesAppliances MillenniumACT Wood Stove Series ACT Wood Stove Series Service and Maintenance Log Lifetime Warranty Contact Information