Quadra-Fire 4300 WOOD STOVE SERIES installation instructions Outside AIR KIT Installation, Part

R

4300 ACT Wood Stove Series

OUTSIDE AIR KIT INSTALLATION

Part 831-1780

Included in Kit: 1 front cover; fiberglass rope; 2 vent straps; venting flange & 4 screws; termination cap & screws. Not all materials are needed for each model.

Items Needed for Installation: 4” (102mm) flex pipe in the length as required for your installation; Phillips screwdriver; Silicone sealant; Drills and saws necessary for cutting holes through the wall or flooring in your home.

1.Remove all materials from packing box.

2.Using a #2 Phillips screwdriver, remove 2 bolts beneath the ashcatcher. Reuse bolts to install front cover. Be certain that the cover is pushed back as far as possible.

3.Install side covers to each side. Slide covers into area and secure with 4 sheet metal screws.

4.Floor installation: Cut a 4” (102mm) minimum hole in the floor to accommodate outside air piping. Use 4” (102mm) metal flex or rigid piping to directly connect outside air to the unit or into vented crawl space. (Do not put flex into a non-vented crawl space). Use the supplied termination cap with a rodent screen. Seal between the floor and the pipe with silicone to prevent moisture penetration. Install fiberglass sealing rope under each side of pedestal.

5.Rear/wall installation: (Millennium Model only, use the knockout plate in rear of the pedestal for exterior wall venting.) Cut a 4” (102mm) hole in outside wall to accommodate outside air piping. Use 4” (102mm) metal flex or rigid piping to directly connect outside air to stove intake. Use the supplied termination cap with a rodent screen. Seal between the wall and the pipe with silicone to prevent moisture penetration. Install fiberglass sealing rope under each side of pedestal.

MILLENNIUM MODEL

FLEX FLANGE

(if needed for rear exit.)

FRONT COVER

SIDE COVER (2) C

L

4-3/8" (111mm)

FIBERGLASS SEALING ROPE

4" (102mm) FLEX LINE

(Not Included)OUTSIDE AIR

TERMINTATION CAP

(contains rodent screen)

		UNI-BODY
	PEDESTAL MODEL
FRONT		(Cut-away
		view)
COVER
FIBERGLASS		4" (102mm) FLEX LINE
	SIDE	(Not Included)
SEALING		FLEX
ROPE	COVER (2)	FLANGE
		OUTSIDE AIR TERMINATION CAP
		(contains rodent screen)

	4" (102mm) FLEX LINE
FRONT	(Not Included)
COVER
	FLEX
SIDE	FLANGE
COVER (2)	OUTSIDE AIR TERMINATION
	CAP
	(contains rodent screen)

250-7061C December 10, 2004 Page 19