Quadra-Fire 4300 WOOD STOVE SERIES Pedestal or LEG KIT Installation Pedestal Model, LEG Model

R

4300 ACT Wood Stove Series

PEDESTAL OR LEG KIT INSTALLATION

WARNING: DO NOT OPERATE STOVE BEFORE FULLY ASSEMBLING ALL COMPONENTS. BURNING YOUR STOVE WITHOUT A PEDESTAL OR LEG KIT ATTACHED WILL VOID YOUR WARRANTY AND COULD PRESENT A SAFETY HAZARD.

PEDESTAL MODEL

1 Place protective pad or stove pallet on floor.

2.Lay body of stove on its back on protective pad or pallet.

3.Loosen screws on adapter and slide pedestal over adapter on bottom of stove

4.Line up holes in sides of pedestal with holes in adapter.

5.Securely tighten pedestal into place.

6.Carefully stand stove up and place in desired loca- tion.

7.Slip wooden decorative strips onto pedestal edges.

8.Open door of stove and check to make sure firebricks and ceramic blanket are in their proper locations (see pages 24-25).

If installing legs, remove these screws to attach leg brackets to bottom of stove

Figure 17A

LEG MODEL

1.Remove leg mounting brackets packaged inside fire- box.

2.Place protective pad or stove pallet on floor.

3.Lay body of stove on its back on protective pad or pallet.

4Remove the bolts, using a 9/16” Hex Head socket or wrench, from the adapter and save.

5.Secure mounting brackets to the bottom of the stove with 1/4”-20 Phillips screws. These screws are located on the outer skin at the bottom rear of the stove. See

Figure 17A.

6.Loosely assembly bolts into the corner of the mounting brackets.

7.Slide legs onto mounting brackets and tighten.

8.Carefully stand stove up and place in desired location.

9.Use leveling bolts on legs to stabilize and level stove.

10.Open door of stove and check to make sure firebricks and ceramic blanket are in their proper locations (see pages 24-25).

LEG MOUNTING BRACKETS

(packaged inside stove firebox).

Figure 17B

CAUTION! DO NOT TILT THE UNIT ON THE CAST IRON LEGS. Lift the unit upright and place it into position on the floor protector.

250-7061C December 10, 2004 Page 17