Quadra-Fire 4300 WOOD STOVE SERIES Door Handle Assembly, Baffle Removal and Installation

Page 25

R

4300 ACT Wood Stove Series

DOOR HANDLE ASSEMBLY

SEE PAGE 20 FOR OPERATING INSTRUCTIONS

1.

Install washer on door handle shaft.

2.

Slide door handle through door.

3.

Install second washer(s) as shown.

4.

Install key in groove.

5.

Align groove in latch cam with key; slide latch

 

cam over shaft.

6.

Install locknut.

 

CAUTION! DO NOT OVERTIGHTEN LOCKNUT.

 

DOOR HANDLE NEEDS TO MOVE SMOOTHLY.

7.

Install spring handle turning in a counter-clock-

 

wise motion on handle leaving a 3” (76mm)

Latch Cam

Locknut

Secondary

Latch

Door Cross Section (example)

3" (76mm) clearance

required from bend in Door Handle Rod to end of Spring Handle.

Spring

Handle

Door Handle

Spacing

Washers FIGURE 25A

Square Key

clearance from bend in door handle rod to end

of spring handle. See Figure 25A.

SPRING HANDLE WARNING!

3” (76mm) clearance is required from bend in Door Handle Rod to end of the Spring Handle. If installed within that 3” (76mm) area, Spring Handle will get hot and may cause injury.

BAFFLE REMOVAL AND INSTALLATION

NOTE: The baffle in the 4300 is 2700° Fiber Board. Removing hardware exposed to combustion processes can be frustrating. If your reason for removing the baffle is simply to clean the chimney, you have alternatives which will save time and effort. Call a qualified chimney sweep or an authorized Quadra-Fire dealer for details.

1.Remove all ash from the firebox, and extinguish all hot embers before disposal into a metal container.

2.With a 3/16” allen wrench, remove the 2 front secondary combustion tube retainer bolts on the secondary air channel under the end of the front tubes. See Figure 25B. NOTE: Soak the bolts with penetrating oil for at least 15 minutes before trying to remove them.

3.To remove the secondary combustion tubes, slide the tube to one side until one end is out of its hole. Then, while lifting that end of

the fiber board, pull the tube up over the secondary air channel and out of the hole at the other end.

NOTE: When replacing the secondary tubes, be sure the tube with the larger holes is placed in the front or your stove will not operate properly.

4.Slide fiber board and ceramic blanket forward to front of stove, tilt down and slide to the door. Tilt to one side and slide both through door at the same time. Keep them tilted as you lift it out of the door. See Figure 25C.

5.To install the fiber board baffle and ceramic blanket, repeat steps 2 through 4 in reverse. Be sure that the fiber board baffle is pushed back fully and the blanket is down flat. The front of the blanket should be flush with the front of the baffle.

First tube has larger holes

Allen wrench on retainer bolt

FIGURE 25B - Allen wrench on retainer bolt.

Ceramic Blanket

Fiberboard Baffle

FIGURE 25C - Baffle and Ceramic Blanket .

250-7061C December 10, 2004

Page 25

Image 25
Contents Wood Stove Series ACT Wood Stove Series Table of Contents Installation Materials Needed for Safety Listings & Safety CautionsDimensions Step TOP UNI-BODY Pedestal Model Locating Your Stove Vent SpecificationsClearances to Combustibles UL and ULC USA -4300 Millinneum USA 4300 Uni-Body Step Top Floor ProtectionBoth Models USA Required Canada RecommendedAlternate Materials Worksheet ACT Wood Stove Series Floor Protection Cont’dChimney HEIGHT/DRAFT Masonry Chimney Cont’d Flue SystemsMasonry Chimney Solid Pack Chimney with Metal Supports AS a Thimble Masonry Interior Chimney Connection to a Metal PRE-FABRICATED ChimneyMobile Home Installation ARS Operating and Cleaning ASH Removal System ARS InstallationLEG Model Pedestal ModelLEG Model Pedestal or LEG KIT Installation Pedestal ModelMillennium Only TOP Heat Shield INSTALLATION, Part Installation of Optional BLOWER, PartAdjusting the Blower Speed CONTROL, if Necessary Part Outside AIR KIT InstallationAIR Controls Operating InstructionsBuilding a Fire ACT Wood Stove Series Operating Instructions Cont’dBurn Rates OpacityWood Selection and Storage Blower Operating InstructionsCreosote Chimney CleaningFirebrick Glass CareGlass Replacement Brick Replacement InstructionsPart Replace with 5mm ceramic glass only Baffle Removal and Installation Door Handle AssemblySpring Handle Warning Exploded Views DOOR, Glass and Door Handle AssemblyModel Shown Step Top Uni-Body Service Parts AccessoriesAppliances MillenniumACT Wood Stove Series ACT Wood Stove Series Service and Maintenance Log Lifetime Warranty Contact Information