Quadra-Fire 31M-ACC-MBK, 31ST-ACC, 31M-ACC-GT, 31M-ACC-NT owner manual Installing Leg Kit

Page 23

R

3100 Wood Stove Series (ACC)

B. Leg Kit and Ash Removal Installation (ARS) for Step Top Uni-Body

NOTE: The Ash Removal System, must be installed first before installing the legs.

Begin installing the ARS System.

1. Follow steps 1 through 6 on page 21.

Installing Leg Kit

1.

Remove leg mounting brackets packaged inside firebox.

2.

Attach the 2 bottom screws of the mounting brackets to the

 

bottom of the stove with 1/4”-20 Phillips screws. These screws

 

are located in the component pack. Leave the bottom 2 screws

 

loose so you can slide the ash pan assembly bottom slots over

 

the screw heads. This allows the weight of the ash pan to

 

rest on the screws while you are attaching the top 2 screws.

Lay stove flat on its back on protective padding or pallet

Leg Brackets

Ash Drawer

Insert 2 bottom screws loosely

 

Once the ash pan is attached, tighten all screws.

3.

Loosely assemble bolts into the corner of the mounting brack-

 

ets for leg attachment.

4.

Slide legs onto mounting brackets and tighten. Make sure the

 

legs are up against the bracket. There are leveling bolts in 2

 

legs. These leveling legs should be in opposite corners.

5.

Carefully stand stove up and place in desired location. Do NOT

 

tilt up on the cast iron legs, it could damage the legs.

6.

Use leveling bolts on legs to stabilize and level stove.

Finishing the ARS Installation

1. Follow steps 1 through 3 on page 22. See also Figure 22.2.

Leg Mounting Brackets are

packaged inside firebox.

Leveling Legs at

opposite corners

Figure 23.1

Figure 23.2

CAUTION

Do NOT tilt the unit on the cast iron legs.

Tilting could lead to property damage.

Lift the unit upright and place it into position on the floor protector.

March 2, 2007

7033-277C

Page 23

Image 23
Contents Fire Risk Step Top Uni-Body Model Millennium ModelPedestal Model Shown Welcome to the Quadra-Fire Family Wood Stove Series ACCTable of Contents Mobile Home Approved Listing and Code ApprovalsBTU & Efficiency Specifications Appliance CertificationAny such action that may cause a fire hazard Fire Risk Fire SafetyService / Maintenance Tip Asphyxiation RiskWood Stove Series ACC Negative Pressure Appliance needs to draft properly for safetyInspect Appliance & Components and Pre-Use Check List Wood Stove Series ACC Flue Draft ConsiderationsVenting Systems Tools And Supplies NeededMasonry Chimney Wood Stove Series ACC Typical Stove SystemsMillennium Model 3Dimensions and ClearancesAppliance Dimensions 34-1/4 in mm 457mm 14-15/16 19-1/16 in.379mm 484mm 33-1/8 Double Wall Pipe Wood Stove Series ACC Clearances to Combustibles UL and ULCSee Figure InstallationHearth Protection Requirements Millennium ModelWood Stove Series ACC Step-Top Uni-Body Model Fire Risk Asphyxiation Risk Wood Stove Series ACC Outside Air Kit InstallationItems Needed for Installation not supplied Shock Risk Wood Stove Series ACC Blower OptionalVenting Components Chimney Systems 5Chimney RequirementsSolid Pack Chimney with Metal Supports as a Thimble ComponentsAir Clearances InstructionsChimney Height / Rise and Run Installing Chimney ComponentsSolid Pack Chimney with Metal Supports as a Thimble Cont’d Rule Wood Stove Series ACC Chimney Termination RequirementsPart SRV7033-041 for installation in a mobile Home Mobile Home InstallationBegin installing the ARS System 7Appliance Set UpStep Top model with a pedestal assembly you must attach Installing Pedestal AssemblyFinishing the ARS Installation Attach the 2 bottom screws of the mounting brackets to Installing Leg KitAdjusting The Blower Speed Control Wood Stove Series ACC Door Handle AssemblyKindling or First Stage Operating InstructionsBurning Process Wood Selection & StorageAir Controls Automatic Combustion Control ACCBurn Rates and Operating Efficiency Wood Stove Series ACC Building a Fire Overfiring Initial cold start-up and all Burn SettingsWood Stove Series ACC Blower Operating Instructions Opacity SmokeIssues Solutions Wood Stove Series ACC Frequently Asked QuestionsDisposal of Ashes General MaintenanceCreosote Chimney Cleaning ARS Operating and CleaningFire Risk Injury Risk Glass ReplacementGlass Cleaning Cleaning Plated SurfacesBrick Size Qty Wood Stove Series ACC Firebrick ReplacementBaffle Wood Stove Series ACC Baffle Removal Snap Disc ReplacementReplacing Tube Channel Assembly Wood Stove Series ACC Tube Channel Assembly ReplacementRemoving Tube Channel Assembly Diagnostic Question Possible Causes of Condition Solutions TroubleshootingDon’t get enough/any heat. What can I do about it? Exploded view Reference MaterialsSizes Step Top Uni-Body Model Item # Accessories Wood Stove Series ACC Service Parts & AccessoriesItem # Service Parts Item # Service Parts Date of Service Performed By Description of Service Wood Stove Series ACC Service And Maintenance LogWood Stove Series ACC Homeowner’s Notes Wood Stove Series ACC Homeowner’s Notes Cont’d Wood Stove Series ACC Warranty Policy Lifetime WarrantyContact Information Wood Stove Series ACC