CHECKING THE WATER
DISPENSER LINE
A water dispenser is just one of the helpful features on your new Samsung refrigerator. To help promote better health, the Samsung water fi lter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms.
You will need to purchase a water purifying system to do that.
In order for the icemaker to operate properly, water pressure of 138 ~862 kPa is required. Under normal conditions, a 170 cc paper cup can be fi lled in 10 seconds.
If the refrigerator is installed in an area with low water pressure (below 138 kPa), you can install a booster pump to compensate for the low pressure.
Make sure the water storage tank inside the refrigerator is properly fi lled. To do this, press the water dispenser lever until the water runs from the water outlet.
Water Line installation Kits are included with unit. You can fi nd it in freezer(or fridge) drawer.
The new
Parts for water line Installation
1 Water line fixer 2 Pipe connector | 3 Water line |
and screws |
|
4 Clip | 5 Water Filter |
Connecting to the water supply line
1.First, shut off the main water supply line.
2.Locate the nearest cold, drinking water line.
3.Follow the Water Line Installation Instructions in the installation kit.
CAUTION
The water line must be connected to the cold water pipe.
If it is connected to the hot water pipe, it may cause the purifier to malfunction.
Close Main |
Water pipe |
Close Main | No gap |
Water pipe |
|
4.After connecting the water supply to the water filter, turn your main water supply back on and Dispense about 3 L to clear and prime the water filter.
SETTING UP
English - 23
2017. 5. 22. 2:38 |