Samsung RFG23UEPN1/SML manual Removing the Refrigerator Doors, Disassemble the Refrigerator doors

When moving your refrigerator

To prevent fl oor damage be sure the front leveling legs are in the up position(above the

floor). Refer to ‘ADJUSTING THE DOORS’ in the manual (at page 10)

FLOORING

For proper installation, this refrigerator must be placed on a level surface of hard material that is the same height as the rest of the fl ooring.

This surface should be strong enough to support a fully loaded refrigerator.

To protect the fi nish of the fl ooring, cut a large section of the cardboard carton and place under the refrigerator where you are working.

When moving, be sure to pull the unit straight out and push back in straight.

Tools you will need(Not provided)

Philips	Flat-blade	Wrench (10 mm)
screwdriver	screwdriver
Pliers	Allen wrench
	(3/16”) (5 mm)

Disassemble the Refrigerator doors

1. With the door opened, remove the Hinge Cover cap 1 with a Flat head screwdriver, and close the door. Remove the 3 screws holding down the Hinge Cover and remove the Hinge Cover

2.

REMOVING THE REFRIGERATOR DOORS

If the Refrigerator is too large to pass through your doorway easily, you can remove the refrigerator doors.

Disconnect power to the refrigerator WARNING before removing the door or drawer.

• Be careful not to drop, damage or scratch the door/drawer while removing them.

•Be careful not to get injured while removing the door/drawer.

•Reattach the door/drawer properly to avoid:

-Moisture from air leakage.

-Uneven door alignment.

-Wasting energy due to improper door seal.

2

1

2.Disconnect two connectors 3 at each side of the top cap, the one connector 7 on right side door and the other connector 4 on left side door. Remove the tube 5 with pressing the dark gray color part 6 of the water line coupler.

3

4

3

7

5

6

8_ Setting up

DA99-03403J-07.indb 8 15. 5. 7. ￿￿ 3:42