Samsung RF62HEVB1/BWT Setting UP Refrigerator, Connecting the water line to the refrigerator

1.First, shut off the main water supply line.

2.Locate the nearest cold, drinking water line.

3.Follow the Water line Installation Instructions in the installation kit.

CAUTION

The water line must be connected to the cold water pipe. If it is connected to the hot water pipe, it may cause the purifi er to malfunction.

Close Main

Water pipe

Close Main	No gap
Water pipe

Connecting the water line to the refrigerator

1.Remove the cap from water line on the unit and insert compression nut to the water line on the unit after disassembling from provided water line.

2.Connect both water line from the unit and water line in the kit.

3.Tighten the compression nut onto the compression fi tting. There should be no gaps between

(A, B & C )

4.Turn water on and check for any leakage.

Remove

cap

Loosen a

Only connect the water line to a drinkable water source.

If you have to repair or disassemble the water line, cut off 6.5mm of the plastic tubing to make sure you get a snug, leak-free connection.

After the water supply has been installed CAUTION check all the joints to ensure there are no

leaks.

•Samsung Warranty does

not cover THE WATER

LINE INSTALLATION.

• The cost of the water line installation is at the

customers expense, unless the retailer has covered this expense in the delivery charge.

•Please contact a Plumber or Authorized Installer for the installation if needed.

•If Water leakage occurs due to improper installation, Please contact installer.

SETTING UP THE

REFRIGERATOR

Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.

1.	Place the Refrigerator in an appropriate location
	with reasonable clearance between the wall and
	the Refrigerator. Refer to installation instructions
	in this manual. (P8. Selecting the best location for
	the Refrigerator)
2.	Once the Refrigerator is plugged in, make sure
	the interior light comes on when you open the
	doors.
3.	Set the Temperature control to the coldest
	temperature and wait for an hour. The Freezer
	will get slightly chilled and the motor will run
	smoothly.
4.	After powering the Refrigerator, it will take a few
	hours to reach the appropriate temperature. You

Water Line

from unit

Water Line

from unit

No gap

can store food and drinks in the Refrigerator after

the temperature is suffi ciently cool.

08_ setting up

DA68-01868T.indb 섹션2:08 2011.7.4 9:22:4 PM