Required Tools (Not provided)
Phillips Head | Flat Head |
Driver(+) | (10mm) (for bolts) |
Hex Wrench | Hex wrench |
(Ø5mm) | (5/32 inch) |
(for Mid hinge) | (for Mid hinge |
| shaft) |
REMOVING THE REFRIGERATOR DOORS
Some installations require door/drawer removal to transport the Refrigerator to its fi nal location.
Do not remove the door/drawer if it is not needed. Before removing the door/drawer make sure you read following items.
Disconnect power to the Refrigerator before CAUTION removing the door or drawer.
• Be careful not to drop, damage or scratch the door/drawer while removing them.
•Be careful not to get injured while removing the door/drawer.
•Reattach the door/drawer properly to avoid:
-Moisture from air leakage.
-Uneven door alignment.
-Wasting energy due to improper door seal.
01 SETTING UP
Disassembling the fridge door
Be careful not to drop and scratch the fridge door while removing the fridge door!
WARNING
Socket wrench
Top Table
1.Remove the 3 screws holding down the top table and remove it.
4.Remove the screw that holds the ground wire with a philips screwdriver(+).
2.Disconnect electric wire on the top of the refrigerator.
5.Separate the hinge from the electric wire and ground wire as shown above.
3.Remove the 3 hex bolts that hold the hinge on the top of the refrigerator with the 10mm socket wrench.
6.Lift the door straight up to remove. Be careful not to drop and scratch the doors while removing them.
setting up _09
2011.7.4 9:22:4 PM |