•To prevent burns and product damage, do not hook up the water line to the hot water line.
•Do not install the water line in areas where temperatures fall below freezing.
•When using any electrical device (such as a power drill) during installation, be sure the device is insulated or wired in a manner to prevent electric shock.
•All installations must be in a accordance with local plumbing code requirements.
• Water line Kit and water fi lter are not covered by Samsung’s Warranty. The manufacturer (or dealer, installer) of them is responsible for any defects and all the loss caused by water fi lter & water line kit.
•The fi lter should be replaced according to manufacturer (or dealer)’s instruction.
•To order additional water fi lters, please contact the manufacturer (or dealer) of the fi lter.
Check the accessories listed below.
Water line fi xer and screws | Pipe connector |
Water line | Fastner |
| - Refer to ‘MAKING MINOR |
| ADJUSTMENTS BETWEEN |
| DOORS’(on page 14) |
Using the water filter (not provided)
Connecting to water supply line
•The water fi lter must be installed outside the refrigerator.
It is not provided with your new
refrigerator. The fi lter cartridge (8) and holder (9) kit can be purchased
from the retailer where youIncorrect purchased this refrigerator.
•Do not use copper line.
• Cut the tubing, making sure the |
|
|
ends are square and clean. | Correct | 01 |
|
| |
• Connect the plastic line |
| SETTING |
Connect the water line to the fridge |
| |
on the back of your | Cartridge Holder | UP |
fridge to the cartridge |
| |
Clip |
| |
holder outlet (fully insert |
| |
|
| |
the plastic line to the |
|
|
cartridge holder outlet). |
|
|
•Insert plastic clip to the
cartridge holder inlet and | Plastic line |
|
outlet. | (Provided) | Filter |
• Turn water on and check |
| cartridge |
for any leakage. |
|
|
• You can purchase the necessary fi lter cartridge at the retailer where you purchased this refrigerator. Make sure you buy the SAMSUNG fi lter cartridge (Replacement cartridge No : DA29- 10105J) to ensure the best performance.
• Water line must be connected to drinkable water only
• A compression fi tting and nut kit is supplied with the unit and it is inside the fridge drawer.
• When pushing the Refrigerator back, make sure you don’t roll over the power cord or water line (Icemaker supply line)
To use without the water filter
•Shut off the main water supply line and turn the Ice maker to the off position.
•Locate the nearest cold drinking water line.
•Follow the instructions in the water fi lter installation kit.
•After connecting the water supply line to the Cartridge Holder inlet and installing the Filter Cartridge (insert plastic line in fully).
•Turn on water supply and
fl ush 3L into a bucket to clear the water fi lter.
90 degree
1.Cold Water line
2.Pipe Clamp.
3.Plastic line
4.Compression Nut
5.Compression Sleeve
6.Packing Nut
7.Shut Off Valve
8.Filter Cartridge
9.Cartridge Holder
section
Connecting to the water supply line
•Shut off the main water supply line and turn the Ice maker to the off position.
•Locate the nearest cold water drinking line.
1. Cold Water line
2. Pipe Clamp.
3. Plastic line
4. Compression Nut
5. Compression Sleeve
6. Packing Nut.
7. Shut Off Valve
setting up _07
2011.7.4 9:22:3 PM |