Napco Security Technologies GEM-RP3DGTL manual RF Low Battery Wireless sys

Page 27

G L O S S A RY

Manager's Mode - In a partitioned system, a low-security operating mode that allows arming by area.

Panic Buttons - Blue buttons on the keypad (G and 7, 8 or

9). If enabled, pressing G to- gether with 7, 8 or 9 will alert the central station of a fire, auxil- iary, or police emergency.

Partitioned System - A system that has been subdivided into two or more (up to eight) independent subsystems (areas).

Pre-Alarm Warning. - A keypad sounder alert of an impending alarm. This option is programmable by zone for the same duration as that pro- grammed for Abort Delay (see Abort Delay).

Report - A transmission to a central station notifying of a change in the status of the system (alarm, trouble, low battery, etc.).

RF Low Battery - (Wireless sys

tems only) Weak transmitter bat- tery.

RF Check In - (Wireless systems only) Periodic test report from trans- mitter (if a report is not received on time, a supervisory-failure system trouble will result).

Ringback - A beep after arming verifying the central-station's receipt of a closing report.

Service Code - A code intended for temporary use.

Sounder - A local warning device at each keypad to alert that (a) entry delay has started; (b) an attempt was made to arm with a zone in trouble; (c) a Day-Zone condition exists (see Zones: Day Zone); (d)

10 seconds exit time remaining; (e) invalid code entered; or (f) central station acknowledged arming (see Ringback).

System Trouble - A problem (low battery, power failure, etc.) detected in the system.

Trouble - A zone fault; an open door, window, or other problem that may prevent arming.

User Code - Your personalized code for arming and disarming the system. It may contain up to six digits.

Zones - Independent circuits that protect specific areas of the premises:

∙Auto-Bypass Zone: A zone that will be automatically bypassed from the protection system if it is in trouble (faulty) when the sys- tem is armed.

∙Burglary Zone: Detects intru- sion.

∙Day Zone: A zone that will cause a visual and audible indica- tion at the keypad if it is in trouble while disarmed.

27

GEM-RP3DGTL.pub

Wednesday, August 18, 1999 14:03

page 27

 

Page 26 Page 28
Image 27
Page 26 Page 28
Contents ENT GEM-RP3DGTL KeypadImportant Test Your System Weekly T R O D U C T I onTable of Contents ENT A1 Keypad Controls & Indicators GeminiFunction Button. Selects available Keypad Controls & IndicatorsSetting the Alarm Arming When Leaving To arm any area Area Arming OptionalProtecting Yourself While on the Premises Bypassing Interior ZonesInstant Protection Emergency Buttons Only available if programmed Alarm Indication Turning OFF the Alarm Disarming When ReturningAmbush Ambush programmed? YES no Fire-Zone Alarm Fire ProtectionFire-Zone Trouble Preparing a Fire Escape Plan Would You Like More Safety Information?Floorplan Limitations of Fire Alarm Warning Systems Keypad Functions Interior Bypass FIRE/TBL SYS TBL YES Keypad Functions Keypad Functions Central Station Monitoring Communicator FeaturesSecurity Bypass/Unbypass Advanced FeaturesExit-Delay Restart Programming Optional IntroductionProgramming User Codes Programming Example O S S a RY RF Low Battery Wireless sys O S S a RY System Trouble Error Codes T ES T ES Following Statement is Required by the FCC Napco Limited Warranty
Top Page Image Contents