PROGRAMMING (OPTIONAL)
6.Continuing, set the cursor to the user code with the A button and enter
the new User Code using the number but- tons. Press G0 for any blank loca- tions until you end up back to the flashing “UP”.
7. Press the Jbutton to save the code
in memory.
Repeat Steps 4 through 7 for each user.
Note: To void a code, simply enter the
ton.
Programming Example
Example. Program User 3's Code as “3784”.
1.Select the Program Mode as follows:
(a) Enter your code, then press the
Abutton.
To Program User Codes
1. Enter program code, then press the A button.
2. Press NO (F) until “17”
displays, then press YES (E).
3. When “UP” displays with a flashing light, use the number buttons to enter a
4. Press the Jbutton to save.
5. Repeat steps 3 & 4 to enter all user codes.
6. Press the C button to exit.
NOTE: Press G0button to clear character at cursor.
To continue press E or F button.
Programming User Codes
(b) Answer NO (F button) repeatedly until “17” is displayed, then press the YESE( button). The display will scroll “P” followed by 4 digits (for installer's use), then “UP” (indicating user programming) and the lights will continue to flash.
2.Press the A button then 03 to enter User No. 3, then press the A button again followed by 3784G0G0 to program the code.
25
Wednesday, August 18, 1999 14:03 | |
page 25 |
|