FIRE PROTECTION
(Applicable only where local ordinance permits use of this alarm control panel for fire protection.)
08
INTERIOR | BYPASS | FIRE/TBL | SYS TBL | CHIME |
Fire-Zone Alarm
If a fire is detected, the “FIRE TBL” light will display with the zone number and the keypad sounder will pulse.
1.If a fire is in progress, evacuate the premises immediately! If necessary, call the Fire Department from an outside phone.
2.If there is no evidence of a fire, enter your code and press the Jbutton to turn
off the alarm.
3.Check smoke detector(s). If a smoke detector tripped, its red alarm indicator light will be on.
4.Press the C button to silence the keypad sounder.
5.After the alarm condition is corrected (thermostat cooled down; smoke cleared from detector; etc.), pressing the C button again will reset the keypad within about 10 seconds.
08
INTERIOR | BYPASS | FIRE/TBL | SYS TBL | CHIME |
Fire-Zone Trouble
1.If a problem on a fire zone is detected, the zone number will display along with the “FIRE TBL” (fire trouble) light, a flashing “SYS TBL” light and the sounder will pulse to signal a malfunction.
2.Press the C button to silence the sounder. Call for service immediately!
12
Wednesday, August 18, 1999 14:03 | |
page 12 |
|