FIRE PROTECTION*
If a fire is detected, the siren will sound a distinct pulsating tone and the FIRE indicator on the Ga- rage Touchpad will be flashing. If a Fire Alarm does occur:
| FIRE | * Note: This feature may not apply to your system. Consult your installer to determine if your system includes fire protection. | |
|
| ||
|
| ||
1 | If a fire is in progress, evacuate the premises immediately! Call the Fire Department from an outside phone. | ||
2 |
| If there is no evidence of a fire, press SILENCE OR insert your | |
| The siren will silence, and FIRE on the Garage Touchpad will stop flashing, and light steady. | ||
|
| ||
|
|
| |
3 |
| Determine which device went into alarm. If you are protected by smoke detectors, the light on the | |
| active detector will be lit. Once it is determined which smoke detector is in alarm, press SILENCE to | ||
| reset the smoke detector. | ||
|
|
| |
4 | FIRE | If the Fire Zone has reset properly, the FIRE light should go out in approximately 30 seconds. If it | |
does not go out, press SILENCE again in a few minutes. If it still does not go out, call for service. | |||
| |||
TBL
The system is constantly monitoring the Fire Zone to insure the connections to the protective de- vices are in good working order.
•If a problem on a Fire Zone is detected, a System Trouble will display. The sounder will activate and the Trouble TBL light will blink 7 times.
Press the SILENCE button to silence the sounder. Call for service immediately.
15