Napco Security Technologies F-TPG manual Garage Touchpad Controls, Emergency Buttons

Page 5
Note: This feature may not apply to your system. Consult your installer to determine if your system in-

GARAGE TOUCHPAD CONTROLS

STAY Button - Press to arm system in the STAY mode. Perimeter devices such as windows and doors will be protected, while interior protective devices such as motion sensors will be de-activated, allowing free movement throughout the premises.

AWAY Button - Press to arm system in AWAY mode when no one is to remain home. System will be fully armed with all perimeter and interior devices activated.

BYPASS Button - This button has multiple functions, depending on the state of the panel.

BYPASS - If you are attempting to arm the system with open zones that cannot be immediately repaired, press BYPASS to tempo- rarily remove these zones from the system. The Touchpad will beep and trouble TBL will light steady. Press STAY or AWAY to arm the system as usual (see page 7).

TEST - To test the system, hold down the BYPASS button for 4 seconds to generate a test report to central station and chirp the siren. If the test fails, the Touchpad will beep and the trouble light (TBL) will flash. Hold down BYPASS for 8 seconds to do a “system walk test” of your protective devices. Press SILENCE to reset. (See page 2).

SILENCE Button - Press to silence a Fire Alarm* (page 15), silence system troubles and view system trou- bles (page 17). *

cludes fire protection.

Hold down for 4 seconds to remove F-IFOBs from the System - See page 20.

EMERGENCY BUTTONS

POLICE EMERGENCY Press to alert Central Station of a Police Emergency.

FIRE EMERGENCY Press to alert Central Station of a Fire Emergency.

AUXILIARY EMERGENCY Press to alert Central Station of an Auxiliary Emergency.

SIREN - Will sound a LOUD steady sweep tone when intrusion is detected or a distinct pulsating tone for a fire alarm condition.

MOTION SENSOR - Detects movement in the premises. Do NOT block.

F-IFOB- The F-IFOB is a uniquely coded digital key which must be used to disarm the system and silence the siren in case of alarm. To silence an alarm, simply insert into the F-IFOB slot on the Touchpad and remove when alarm has silenced.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Napco Important Test Your System Weekly IntroductionTable of Contents Ready Armed Stay Fire TBL Garage Touchpad IndicatorsEmergency Buttons Garage Touchpad ControlsPress the Away button on the Touchpad Arming When LeavingSystem will arm with the faulted zones bypassed Bypassing Faulted ZonesPress the Bypass button Press either the Stay or Away buttonPress the Stay button on the Touchpad Arming When Staying HomeArming and Leaving with Others Staying Check the Garage Touchpad indicatorsExit the garage Exiting with the System Already ArmedIndicate the system has armed Emergency Buttons Disarming the System Disarming When Returning HomeIf an alarm occurs while you are away Silencing AN AlarmIf an alarm occurs while you are at home Fire Fire ProtectionPreparing a Fire Escape Plan Would You Like More Safety Information?Family Rehearsal Important! Read CarefullyReady System Trouble Error CodesNone Zone List Removing IFOBs from the system Enrolling a NEW F IfobAdding additional IFOBs to your system Lost Opener Mode Lost GAR AGE Door Opener ModeFederal Communications Commission FCC Part 68 Statement Page Page Napco Limited Warranty Page Following Statement is Required by the FCC Publicly traded on Nasdaq Symbol Nssc
Top Page Image Contents