Napco Security Technologies F-TPG manual

Page 23

WARNING! THE LIMITATIONS OF THIS ALARM SYSTEM

While this system is an advanced design security system, it does not offer guaranteed protection against burglary or fire or other emergency. Any alarm system, whether commercial or residential, is subject to compromise or failure to warn for a variety of reasons. For example:

Intruders may gain access through unprotected openings or have the technical sophistication to bypass an alarm sensor or disconnect an alarm warning device.

Intrusion detectors (e.g. passive infrared detectors), smoke detectors, and many other sensing devices will not work without power. Battery operated devices will not work without batteries, with dead batteries, or if the batteries are not put in properly. Devices powered solely by AC will not work if their AC power supply is cut off for any reason, however briefly.

Signals sent by wireless transmitters may be blocked or reflected by metal before they reach the alarm receiver. Even if the signal path has been recently checked during a weekly test, blockage can occur if a metal object is moved into the path.

A user may not be able to reach a panic or emergency button quickly enough.

Passive Infrared Motion Detectors can only detect intrusion within the designed ranges as diagrammed in their installation manual. Passive Infrared Detectors do not provide volumetric area protection. They do create multiple beams of protection, and intrusion can only be detected in unobstructed areas covered by those beams. They cannot detect motion or intrusion that takes place behind walls, ceilings, floors, closed doors, glass partitions, glass doors, or windows. Mechanical tampering, masking, painting or spraying of any material on the mirrors, windows or any part of the optical system can reduce their de- tection ability. Passive Infrared Detectors sense changes in temperature; however, as the ambient temperature of protected area approaches the temperature range of 90° to 105°F (32° to 40°C), the detection performance can decrease.

Alarm warning devices such as sirens, bells or horns may not alert people or wake up sleepers if they are located on the other side of closed or partly open doors. If warning devices sound on a different level of the premises, then they are less likely to alert all people. Persons may not hear the warning if the alarm is muffled from a stereo, radio, air conditioner or other appliance, or by passing traffic. Finally, alarm warning devices, however loud, may not warn hearing-impaired people.

Telephone lines needed to transmit alarm signals from a premises to an alarm monitoring center may be out of service or temporarily out of service. Telephone lines are also subject to compromise by sophisticated intruders.

-Continued over

23

Image 23
Contents Napco Important Test Your System Weekly IntroductionTable of Contents Ready Armed Stay Fire TBL Garage Touchpad IndicatorsEmergency Buttons Garage Touchpad ControlsPress the Away button on the Touchpad Arming When LeavingPress either the Stay or Away button Bypassing Faulted ZonesSystem will arm with the faulted zones bypassed Press the Bypass buttonPress the Stay button on the Touchpad Arming When Staying HomeArming and Leaving with Others Staying Check the Garage Touchpad indicatorsExit the garage Exiting with the System Already ArmedIndicate the system has armed Emergency Buttons Disarming the System Disarming When Returning HomeIf an alarm occurs while you are away Silencing AN AlarmIf an alarm occurs while you are at home Fire Fire ProtectionImportant! Read Carefully Would You Like More Safety Information?Preparing a Fire Escape Plan Family RehearsalReady System Trouble Error CodesNone Zone List Removing IFOBs from the system Enrolling a NEW F IfobAdding additional IFOBs to your system Lost Opener Mode Lost GAR AGE Door Opener ModeFederal Communications Commission FCC Part 68 Statement Page Page Napco Limited Warranty Page Following Statement is Required by the FCC Publicly traded on Nasdaq Symbol Nssc