Napco Security Technologies F-TPG Arming When Leaving, Press the Away button on the Touchpad

Page 6

ARMING WHEN LEAVING

If you are leaving with NO other family members remaining home:

1

READY

Check the Garage Touchpad indicators. The green READY light should be ON-STEADY, indicating

that the system is ready to arm.

 

 

 

 

 

If the green READY light is BLINKING, this indicates that a zone is faulted. The READY light is blinking out the zone

 

 

number of the open zone. Count the flashes and look at your zone list to see which zone is open and secure it (close

 

 

the door or window, etc.). If you cannot immediately secure the zone, it may be bypassed (see page 7).

 

 

If the green READY light is OFF, the optional second deadbolt is not locked. If there are two deadbolts in the system,

 

 

the other deadbolt must be locked before the system can be armed. Go to the other deadbolt location and lock it.

 

 

 

2

 

Press the AWAY button on the Touchpad.

 

If you change your mind after pressing AWAY, press SILENCE to clear arming.

 

 

 

 

 

 

ARMED

The ARMED indicator will begin to flash, indicating that you have up to 3 minutes to exit through the

 

garage and close the door.

 

 

3

 

Open the garage door and exit within 3 minutes. (Note: See page 13 if your garage door motor fails).

 

 

4

 

When the garage door closes (either by pressing A1 or A2 on your Keyfob or with your standard garage

 

door opener remote control), the Garage Touchpad will give one chirp to indicate the system has armed.

 

If the garage door has not been closed within 3 minutes of pressing AWAY, the system will revert

back to a disarmed state.

If the system detects movement inside the premises within 3 minutes of arming, it will automati- cally revert to Stay mode, providing perimeter protection with the interior protection (motion sen- sors) turned off. (See ARMING WHEN STAYING HOME - page 8).

6

Image 6
Contents Napco Introduction Important Test Your System WeeklyTable of Contents Garage Touchpad Indicators Ready Armed Stay Fire TBLGarage Touchpad Controls Emergency ButtonsArming When Leaving Press the Away button on the TouchpadPress the Bypass button Bypassing Faulted ZonesSystem will arm with the faulted zones bypassed Press either the Stay or Away buttonArming When Staying Home Press the Stay button on the TouchpadCheck the Garage Touchpad indicators Arming and Leaving with Others StayingExiting with the System Already Armed Exit the garageIndicate the system has armed Emergency Buttons Disarming When Returning Home Disarming the SystemSilencing AN Alarm If an alarm occurs while you are at homeIf an alarm occurs while you are away Fire Protection FireFamily Rehearsal Would You Like More Safety Information?Preparing a Fire Escape Plan Important! Read CarefullySystem Trouble Error Codes ReadyNone Zone List Enrolling a NEW F Ifob Adding additional IFOBs to your systemRemoving IFOBs from the system Lost GAR AGE Door Opener Mode Lost Opener ModeFederal Communications Commission FCC Part 68 Statement Page Page Napco Limited Warranty Page Following Statement is Required by the FCC Publicly traded on Nasdaq Symbol Nssc