Monessen Hearth TPB30, TPB24, TPB18 manual Product Features and Specifications

Page 6

PRODUCT FEATURES AND SPECIFICATIONS

NATURAL GAS

NOTE: An external regulator is required to reduce supply pressure to a maximum of 10 1/2" W.C. on natural gas systems operating at higher pressure.

MILLI-VOLT

 

Model Number

Control

Gas Rate

Regulator Pressure Setting: 3.5" w.c.

Max BTU/Hr

Min BTU/Hr

TPB18NV

Milli-Volt

28,000

19,000

Pilot Regulator:

3.5" w.c.

TPB24NV

Milli-Volt

38,000

26,000

Gas Inlet Pressure:

Max 101/2" w.c.

TPB30NV

Milli-Volt

38,000

26,000

 

 

 

Min. 5" w.c.

 

 

 

 

 

 

 

 

 

PROPANE/LPG

Note: An external regulator is required to reduce supply pressure to a maximum of 13" w.c.

MILLI-VOLT

 

 

 

Gas Rate

Regulator Pressure Setting: 10" w.c

Model Number

Control

Max BTU/Hr

Min BTU/Hr

Gas Inlet Pressure:

Max. 13" w.c.

TPB18PV

Milli-Volt

28,000

23,000

TPB24PV

Milli-Volt

34,000

26,000

 

Min. 11" w.c.

 

TPB30PV

Milli-Volt

34,000

26,000

 

 

IGNITION CONTROLS

Piezo ignitor allows ignition of the pilot without the use of matches or batteries.

Milli-Volt control has four (4) positions:

OFF

- All gas to the gas logs is shut off at the valve.

IGN

- Valve position to light/maintain a standing pilot.

ON

-

Valve position to turn ON/OFF log set with remote switch/thermostat.

LOW/HI

-

Variable position to control flame height (heat output).

PILOT/ODS

The gas log heater is fitted with a specially designed safety pilot (ODS assembly) which senses the amount of oxygen avail- able in the room and shuts the gas log heater off if the oxygen level begins to drop below a satisfactory level. The pilot can only be relit when adequate fresh air is available.

THERMAL GENERATOR

The millivolt gas log pilot is fitted with a milli-volt (thermopile) generator to provide power for remote activation.

6

70D0004

Image 6
Contents Read and Save These Instructions What to do if YOU Smell GASContents Important Safety Information InstallerOwner Massachussetts Residents only What YOU will Need for Installation Getting StartedMake Sure YOU have Received ALL Parts Product Features and Specifications General Installation Information CodesAdequate Combustion and Ventilation AIR BTU / Hr = Fireplace and Hearth Dimensions Hearth Minimum DimensionPlacement in a Fireplace with a Restrictive Barrier Height of Restriction Minimum Depth of Fireplace/FireboxClearances and Height Requirements Sidewall and Ceiling ClearancesClearances and Height Requirements Measuring Heat Resistant Material for Mantel Minimum Mantel Clearance with No Hood -TPB18 Mum of 10 at a minimum of 28 above the opening Floor Clearance Minimum Clearance above Combustible FlooringBefore Installing the Appliance Installing Vented ApplicationsBefore Fully Installing the Unit Damper Stop InstallationInstalling Vented Applications Assembly ProcedurePlacing and Securing Appliance Connecting the GAS Flexible Tube Manual Shutoff Gas Supply Inlet ValveChecking GAS Pressure MILLI-VOLT Valve Control FigureElectrical Wiring MILLI-VOLT Connecting Optional Wall Switch or ThermostatATE Connecting Remote Receiver Checking System OperationComplete MILLI-VOLT System Check LOG Placement Installing Charred Timber Logs on BurnerInstalling Left Base Log #3 Installing Left Top Log #5 Installing Right Top Log #6 Placing Rock WoolRiser and Steel BAR Grate Installation Optional Riser InstallationSteel BAR Grate Installation Optional Cast Iron Grate and Andiron Installation Cast Iron Grate InstallationAndiron Installation Checking the Pilot Flame Flame AppearancePlacing the Decorative Rock MILLI-VOLT Control and Thermostat ControlChecking the Burner Flame Operating InstructionsOperating Instructions What to do if YOU Smell GASTo Turn OFF GAS to Heater Operating Instructions and Cleaning and Servicing Cleaning and ServicingTroubleshooting Observed Problem Possible Cause RemedyODS/pilot lights, but flame Replacement Parts Burner AssemblyReplacement Parts List Accessories Sold SeparatelyCharred Timber Logs CTCL18 CTCL24 CTCL3070D0004 Carbon Monoxide Detector Requirements Special Requirements Lifetime Warranty Five Year WarrantyBasic Warranty