Monessen Hearth LX36DV, LX32DV operating instructions Code Approval, Important Safety Information

Page 4

LX Series Direct Vent Gas Fireplace

IMPORTANT SAFETY INFORMATION

 

 

14.Do not use any solid fuels (wood, coal, paper, card- board, etc.) in this fireplace. Use only the gas type indicated on rating plate.

15.This appliance, when installed, must be electrically grounded in accordance with local codes or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1.

16.Do not obstruct the flow of combustion and ventilation air in any way. Provide adequate clearances around air openings into the combustion chamber along with adequate accessibility clearance for servicing and proper operation.

17.When the appliance is installed directly on carpeting, tile or other combustible material other than wood flooring, you must set appliance on a metal or wood panel or hearth pad extending the full width and depth of the appliance.

18.Do not use fireplace if any part has been exposed to or under water. Immediately call a qualified service person to arrange for replacement of the unit.

19.Do not operate fireplace if any log is broken.

20.Do not use a blower insert, heat exchanger insert, or any other accessory not approved for use with this fireplace.

21.Do not operate the fireplace with glass door removed, cracked, or broken.

22.For Massachusetts Residents Only: This product must be installed by a licensed plumber or gas fitter when installed within the Commonwealth of Massa- chusetts. Flexline installation must not exceed 36".

!WARNING

HOT GLASS WILL

CAUSE BURNS.

DO NOT TOUCH GLASS

UNTIL COOLED.

NEVER ALLOW CHILDREN

TO TOUCH GLASS.

IMPORTANT:

PLEASE READ THE FOLLOWING

CAREFULLY

It is normal for fireplaces fabricated of steel to give off some expansion and/or contraction noises during the start up or cool down cycle. Similar noises are found with your furnace heat exchanger or car engine.

IMPORTANT:

PLEASE READ THE FOLLOWING

CAREFULLY

It is not unusual for gas fireplace to give off some odor the first time it is burned. This is due to the manufacturing process.

Please ensure that your room is well ventilated during burn off — open all windows.

It is recommended that you burn your fireplace for at least ten (10) hours the first time you use it. Place the fan switch in the “OFF” position during this time.

 

WARNING

Never connect unit to private (non-utility)

 

 

 

 

gas wells. This gas is commonly known

 

 

as wellhead gas.

 

 

 

Code Approval

Direct Vent type appliances draw all combustion air from outside of the dwelling through the vent pipe.

These appliances have been tested by CSA and found to comply with the established standards for DIRECT VENT GAS FIREPLACE HEATERS in the USA and Canada as follows:

LISTED VENTED GAS FIREPLACE HEATER

TESTED TO: ANSI Z21.88-2009 / CSA 2.33-2009 STANDARDS

51D0528

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Lexington Direct Vent Gas Fireplace What to do if YOU Smell GASContents CongratulationsImportant Safety Information InstallerOwner Please leave these instructions with the applianceCode Approval Important Safety InformationPlease Read the Following Carefully Product Specifications Gas Specifications & Orifice SizeHigh Elevations GAS pressuresFireplace and Framing Dimensions LX32 Fireplace & Framing DimensionsBefore You Start Installation InformationFireplace Framing Installation Information Fireplace LocationClearances Clearances to combustiblesMantel clearances Hearth requirements For the exact width of the faceSecure Fireplace to floor or framing Finishing MaterialAfter conversion to top vent configuration Optional top vent application4 102 mm flue pipe should be Concentric within the 6B\, 175 mm outerVenting Installation Installation precautionsFailure to follow these instructions will void the warranty Venting Installation Combustible Clearances for Vent PipeInstallation planning Installing a vent system in an outside chaseFor horizontal termination For vertical terminationVenting Installation General Venting Information Termination LocationHow To Use The Vent Graph Following vent installation instructions to determineVent Graph should be read in conjunction with SystemDo not recess vent termination into any Rear Wall Vent installationWall. This will cause a fire hazard Horizontal through the wall ter- mination configurations Maximum horizontal vent length in a system with a Example According to the vent graph Page 16Elbow Total Angular Variation 270 Below Grade Installations Vertical through-the-roof applica- tionsInstallation for Vertical TERMINA- Tion Flat Ceiling InstallationAssemble the desired lengths of pipe and elbows nec Essary to reach from the burner system flue up throughFirestop. Be sure pipe and elbow connections are Fully twist-locked. Page 17, FigureInstalling gas piping to fireplace location Check gas typeNatural Gas Propane/LPElectrical Wiring Do not connect wall switch to Remote Wall mounted SwitchHeater 110V circuit Final Installation Reinstalling clamps, keep fingers clearGlass Frame Removal Each clamp has a quick spring force. WhenLOG Placement InstalL logs and rock wool ember material in fireboxLogs supplied with the unit Personal injuryRear Log #1 Place top left log #4 on two pins on left mid log. Figure Center Log #8 Air Space Under Rear Log 100% Factory Setting AIR Restrictor Adjustment20 to 50% 30 to Facing Installation Install FacingInitial lighting Leak testing Never use an open flame to check for gas leaksOperating Instructions Approved leak testing method Operating InstructionsLighting the burner Main burner switchPilot position Cleaning and maintenance Cleaning glassFirebox Cleaning Venting systemWiring Diagram for Blower BlowerTroubleshooting Observed Problem Possible Cause RemedyReplacement Parts Replacement Parts Optional Accessories Nantucket Decorative ArchOptional Accessories LX Series Direct Vent Gas Fireplace LX Series Direct Vent Gas Fireplace Carbon Monoxide Detector Requirements Lifetime Warranty Five Year WarrantyBasic Warranty If Warranty Service is NeededMhsc Model EnerGuide Ratings

LX36DV, LX32DV specifications

The Monessen Hearth LX36DV and LX32DV are premium direct vent gas fireplaces designed to provide warmth and ambiance in any living space. Both models showcase innovative engineering and elegant designs, making them a popular choice for homeowners seeking efficient heating solutions.

One of the main features of the LX36DV and LX32DV is their versatile design. Both units are available in various configurations, allowing them to seamlessly integrate into a range of architectural styles, from contemporary to traditional. Their clean face design and beveled edges contribute to a sleek, attractive appearance that enhances any room's aesthetic.

Efficiency is another standout characteristic of these fireplaces. Equipped with advanced gas burner technology, the LX36DV and LX32DV deliver an impressive heat output while maintaining a high efficiency rating. The direct vent system ensures that combustion gases are safely expelled outside, making it a safe alternative to traditional wood-burning fireplaces. This feature not only improves indoor air quality but also contributes to overall energy conservation.

The LX36DV and LX32DV also offer customizable options to enhance user experience. Customers can choose from various front styles, finishes, and media options, allowing for personalization that matches individual tastes. The addition of decorative glass or colorful crushed fireglass can transform the look of the fireplace, creating a unique focal point in the room.

In terms of technology, both models are equipped with remote control capabilities, allowing users to adjust flame height and heat settings from anywhere in the room. This convenience ensures optimal comfort while eliminating the need for manual adjustments. Additionally, these fireplaces come with innovative electronic ignition systems that provide reliable startup every time.

Safety features are prioritized in the design of the LX36DV and LX32DV. Each unit comes with safety screen options and can be modified to include childproof doors, making them a practical choice for families. The advanced flame sensing technology provides peace of mind as it automatically adjusts in response to room conditions.

In conclusion, the Monessen Hearth LX36DV and LX32DV are exemplary gas fireplaces that combine style, efficiency, and safety. With their customizable design, advanced technologies, and user-friendly features, these models stand out in the market, offering unrivaled warmth and elegance to any home. Whether you are heating a cozy family room or making a statement in a grand living area, these fireplaces provide both functionality and charm.
Top Page Image Contents