Monessen Hearth DBX24C* manual Checking the Burner Flame, Operating Instructions

Page 28

CHECKING THE BURNER FLAME

OPERATING INSTRUCTIONS

Avoid any drafts that alter burner flame patterns. Do not allow fans to blow directly into the fireplace. Do not place a blower inside the burn area of the firebox. Ceiling fans may create drafts that alter flame patterns. Sooting and improper burning will result.

During manufacturing, fabricating and shipping, various components of this appliance are treated with certain oils, films or bonding agents. These chemicals are not harmful, but may produce annoying smoke and smells as they are burned off during the initial operation of the appliance, possibly causing headaches or eye or lung irritation. This is a normal and temporary occurrence.

The initial break-in operation should last two to three hours with the burner at the highest setting. Provide maximum ventila- tion by opening windows or doors to allow odors to dissipate. Any odors remaining after this initial break-in will be slight and will disappear with continued use.

This appliance must not be used with glass doors in the closed position. This can lead to pilot outages and severe sooting outside the fireplace.

28

33D4047

Image 28 Contents
Installation and Operating Instructions Models DFX24C DBX24C DFX32CRead and Save These Instructions What to do if YOU Smell GASContents Installer Important Safety InformationOwner Important Safety Information Product Features OperationNatural GAS Propane / LPGPilot Getting StartedThermal Generator General Installation Information DFX24C/DBX24C DFX32CCodes Adequate Combustion and Ventilation AIR15 1/ 2 x 12 x Installing Optional Firebrick Panels Remove fireplace screen See , page 14 and logsBlack Trim Installation DFX24C/DBX24C Attaching Assembled BlackBlack Trim Installation DFX32C Lining Up Corners of Trim KitInstalling Canopy Removing ScreenSecuring Heater to Floor or Hearth Removing GrateLocation of Fireplace Suggested LocationsMinimum42 Fireplace Framing Or /8Custom Cabinet Connecting the GAS Tee Joint Sediment Trap Pipe Nipple Minimum CapChecking GAS Pressure Manual Control FigureElectrical Wiring MILLI-VOLT Connecting Optional Wall Switch or ThermostatOperate That does not Require 110 VAC toChecking System Operation Connecting Remote ReceiverComplete Millivolt System Check LOG Placement Proper Installation Sequence DFX24CProper Installation Sequence DFX32C Proper Installation Sequence DBX24CFlame Appearance Checking the Pilot FlameMILLI-VOLT Control Manual and Thermostat ControlInstalling Rock Wool and Checking Burner Flame CleanPlacing Rock Wool Checking Burner FlameChecking the Burner Flame Operating InstructionsOperating Instructions For Your Safety Read Before LightingWhat to do if YOU Smell GAS Manual Control Lighting Instructions To Turn OFF GAS to HeaterThermostatic Control Lighting Instructions Rotation of Control KnobMILLI-VOLT Control Lighting Instructions PilotCleaning and Servicing Match Lighting InstructionsBlower and Other Optional Equipment Optional EquipmentForced AIR KIT Brass LouversIllustrated Parts Breakdown for Cabinet Accessories Standard FeaturesIllustrated Parts Breakdown DFX24C MILLI-VOLT DFX24C ManualLOG SET Replacement Parts ListParts AVAILABLE, not Shown DFX32C MILLI-VOLT DFX32C Manual 33D5511 DBX24C T-STAT DBX24C T-STAT DescriptionNatural Propane AVAILABLE, not ShownTroubleshooting Observed Problem Possible Cause RemedyTroubleshooting Five Year Warranty Lifetime WarrantyBasic Warranty