Monessen Hearth DBX24C* manual Black Trim Installation DFX32C, Lining Up Corners of Trim Kit

Top Trim Piece

45°-angled

Corners

Back of Trim

Assembly

Side Trim Pieces

Figure 9 - Lining Up Corners of Trim Kit

Outside Corner Slot

90°-angled

Bracket

90°-angled Shim Outside

Corner Slot

Figure 10 - Securing Corners Together

Bracket

Screws

No Spaces

where

Corners Join

Figure 11 - Making Sure Corners Are Flush

Assembled Trim

Trim Flushed

with Front of

Fireplace

Figure 12 - Sliding Assembled Trim Over the Top

of the Heater

BLACK TRIM INSTALLATION (DFX32C)

1.Remove trim from protective packaging. Be careful not to scratch the trim. Remove two (2) 90°-angled mounting brackets and two (2) 90°-angled shims.

2.Lay trim face down on the floor. Line up the 45°-angled corners of the top trim with the 45°-angled corners of the side trims.

Note: Both ends of the top piece of trim are mitered. See Figure 9.

3.Slide one (1) 90°-angled bracket (with attached screws) and one (1) 90°-angled shim in the outside corner slot where the top and side trims meet. See Figure 10.

4.Hold the corners together securely. Tighten screws on bracket with flat head screwdriver. Make sure the corners are flush and there are no spaces. Do not over tighten screws. See Figure 11.

5.Repeat for other side trim.

6.Slide assembled trim over the top and down the sides of the fireplace. Flush trim with front of fireplace as shown in Figure 12.

7.Align holes in assembled trim with holes in side of fire- place. Using a Phillips screwdriver, attach trim with four

(4)screws provided — two for each side of fireplace. Tighten snuggly. See Figure 13.

Screws

Screw

Holes

Screw

Figure 13 - Securing Trim to Heater with Four (4)

Screws Provided