Harman Stove Company 1-90-797000 Appliance Set-Up, Outside Air Attachment Leveling the Appliance

		Oakleaf Woodburning Stove
7	Appliance Set-Up
A. Outside Air Attachment		B. Leveling the Appliance
Parts and Supplies Needed: 1 piece of metal flexible
pipe, 4" X needed length. 1 Rodent Screen, and alu-		To adjust the leveling bolts, you must first loosen the
minum tape. Plus, a trim ring for finishing around the		locking nut. Turn the leveling bolt to the desired posi-
pipe on the inside wall.		tion, and tighten the locking nut against the cast iron
		leg.

1. Determine an appropriate hole location, through the wall. Be sure there are no studs or other sup- porting members. Also ensure there are no electri- cal wires or plumbing contained within the wall.

2. Make the hole through the exterior wall using a hole saw or reciprocating saw. You'll want the hole to be just slightly larger than the metal flex pipe.

3. Attach the rodent screen to one end of the flex
	pipe, and insert it through the wall until the back of			C. Optional Cooking Grill
	the screen cover is against the outside surface.
4. Hold the flex pipe in place to make an accurate				The optional cooking grill #1-00-08121 installs easily
	determination of the length needed. Cut the flex
				in the top load opening of the Oakleaf.
	pipe to length.
				The grill handle (B) fits in the slots (C) on each side.
5. Slide the trim ring onto the flex for the inside wall
				To remove the handle, lower and turn.
	portion.
				When installed, the grill hangs in the opening by the
6. Slide the other end of the metal intake flex pipe
				hooks (A).
	into the stub on the rear of the Oakleaf and secure
				When grilling, you'll want to keep the fire size small
	it with aluminum tape. This air intake will supply
				and the bypass damper in the open position. Depend-
	outside air for the secondary combustion within
				ing on the grilling being done, you may get grease
	the FireDome.
				dripping on the glass causing it to become dirty and
7. Secure the trim ring in place for finishing the inside
				obstructed. When you burn your next hot fire, the
	wall area.
				glass will likely clean itself.
8. Seal around the rodent screen on the exterior wall,
	using silicone caulking.			A
			CAUTION
				B
	Never draw outside combustion air
	from:
	• Wall, floor or ceiling cavity.
	• Enclosed space such as an attic or			A
		garage

C

C

A

Outside Air

Attachment

22 Dry Seasoned Wood Only! 3-90-798 Save These Instructions