Optional Blower Installation | Harman Stove Company 1-90-797000

Oakleaf Woodburning Stove

D. Optional Blower Installation

The optional blower kit #1-00-797032 installs easily to the rear of the Oakleaf.

Hold the blower assembly into place and secure it with the two bolts provided. You'll need a 3/8" wrench or socket to tighten the bolts.

Secure blower with one bolt on each end of the mounting plate.

Notice: When installing the optional blower, the upper rear shield must be moved upward to create the air passage.

Loosen the eight screws to remove the rear shield. Raise the shield to the upper set of holes, re-install the shield, and tighten the screws.

E. Optional Rear-vent Rear Shield

Whenever a rear vent configuration is used, the upper rear heat shield, #1-00-797070 must be purchased and installed, to accomodate the flue collar. There are eight screws that secure the existing shield. You'll need to break away the tabbed portion of the lower shield flue cut-out. Remove the screws from the top-vent shield and install the rear vent shield in it's place. Height adjustment for blower use is done the same as with the top-vent shield in place. See

D.Optional Blower Installation (above) for detailed instructions.

If not installing the optional blower, the upper knockout will need to be removed.

Shown with lower shield knockout removed.

Warning

Route Power cord away from the appliance. Do not run the cord under or in front of the appliance.

Plug the blower into a properly grounded electrical outlet.

You can turn the blower on at any time using the rocker switch on the rear of the blower housing. Set- ting the switch to "AUTO" will keep the blower off until there is a significant amount of heat from the stove. In this setting, the blower will also shut off when the stove cools. Keep the blower on low speed or off dur- ing low fires. As you get out of the low burn range, the speed can be set wherever desired, or kept off.

F. Optional Bottom Heat Shield

Part #1-00-797058 must be purchased and installed whenever the Oakleaf is installed on a protected com- bustible floor. The shield installs on four bolts that are protruding downward from the base of the stove body. Slide the shield under the stove from the back, as this is the only way it will fit. Lift into place guiding the bolts through the holes in the shield and secure with the nuts that are included with the shield.

Save These Instructions

3-90-798

Dry Seasoned Wood Only!