Fujitsu ASU18T, AOU36T, Room Air Conditioner Multi Split Type (3 rooms) operation manual Preparation

Page 9

PREPARATION

Load Batteries (R03/LR03/AAA ⋅ 4)

1Open the battery compartment lid.1 Slide the battery compartment lid until it stops.

2 While strongly gripping the portion on each side of the battery com- partment lid that has a rough surface, slide the lid until it comes com-

pletely off.

2

 

 

1

 

2

2

Insert batteries.

 

2

Be sure to align the battery polarities (

) correctly.

3

Close the battery compartment lid.

 

Set the Current time

 

 

1

Press the TIME ADJUST button.

 

 

Use the tip of a ball-point pen or other small object to press the button.

CAUTION!

●Take care to prevent infants from accidentally swallowing batteries.

●When not using the remote control unit for an extended period, remove the batteries to avoid possible leakage and damage to the unit.

●If leaking battery fluid comes in contact with your skin, eyes, or mouth, immedi- ately wash with copious amounts of water, and consult your physician.

●Dead batteries should be removed immediately and disposed of properly, either in a battery collection receptacle or to the appropriate authority.

●Do not attempt to recharge dry batteries.

Never mix new and used batteries, or batteries of different types.

Batteries should last about one year under normal use. If the remote control unit’s operating range becomes appre- ciably reduced, replace the batteries and press the ACL button with the tip of a ballpoint pen or other small object.

2Use the ()SET TIME buttons to adjust the clock to the current time.

button: Press to advance the time.

button: Press to reverse the time.

(Each time the buttons are pressed, the time will be advanced/reversed in one-minute increments; hold the buttons depressed to change the time quickly in ten-minute increments.)

SET

SWING

SET

ENERGY TIME RUN ACL

SAVE

3

Press the TIME ADJUST button again.

This completes the time setting and starts the clock.

To Use the Remote Control Unit

●The remote control unit must be pointed at signal receiver to operate correctly.

●Maximum operating range: Approximately 10 meters. (This may not apply when the battery is low or there are obstacles.)

●When a signal is properly received by the air conditioner, a beep will be heard.

●If no beep is heard, press the remote control unit button again.

Remote Control Unit Holder

For Hand-Held use

For Wall Mount use

Insert

Slide up

Insert

 

Screws

 

Screws

Slide

 

 

 

Screw

1 Mount the Holder. 2 Set the Remote

3 To remove the

1 Mount the Holder. 2 Set the Remote

3 Attach the unit to

Control Unit.

Remote Control

Control Unit.

the holder as

 

Unit.

 

shown.

En-8

Page 8 Page 10
Image 9
Page 8 Page 10
Contents ASU18T Multi Split Type 3 RoomsAOU36T EnglishSafety Precautions ContentsAIR Cleaning Filter Optional Features and FunctionsPage Name of Parts En-5 Name of PartsOutdoor Unit Intake Side F Outlet Side Time Adjust Button S Test RUN ButtonTo Use the Remote Control Unit Press the Time Adjust button againRemote Control Unit Holder PreparationPreparation Operation To Select Mode Operation Press the START/STOP button PTo Set the Thermostat Press the SET TEMP. buttons L To Set the Fan Speed Press the FAN Control button ODuring Cooling/Dry mode To Set the Thermostat Press the Temperature set buttonDuring Fan mode To Stop Operation Press the START/STOP buttonOperation To Select Mode Operation Press the START/STOP buttonTo Set the Thermostat Press the SET TEMP. buttons To Set the Fan Speed Press the FAN Control buttonAbout Mode Operation Timer Operation To Use the Program timer Press the START/STOP buttonSet the desired times for OFF timer and on timer About the Program timer Sleep Timer OperationAbout the on timer About the Sleep timerTypes of Air flow Direction Setting Adjusting the Direction of AIR CirculationRight-Left Adjustment Adjust the Right-Left louvers Adjusting the Direction of AIR CirculationSwing Operation Manual Auto OperationTo select Swing Operation Press the Swing Louver button R To Stop Vertical airflow Swing Operation Swing OperationTo Stop Horizontal airflow Swing Operation About Swing OperationEnergy Save Operation Manual Auto OperationAbout the Energy Save Cleaning and Care Clean with water Cleaning the Intake Grille Open the Intake GrilleUnlock the Intake Grille Lock the Intake GrilleSymptom Problem TroubleshootingEn-23 Operating Tips Temperature and Humidity Range

ASU18T, Room Air Conditioner Multi Split Type (3 rooms), AOU36T specifications

The Fujitsu AOU36T is a highly efficient multi-split room air conditioning system designed to provide optimal comfort across three rooms. Its versatility and advanced technology make it an ideal solution for residential and commercial spaces. With a combination of the outdoor unit (AOU36T) and indoor units (ASU18T), this system showcases Fujitsu's commitment to quality and performance.

One of the main features of the AOU36T system is its energy efficiency, classified with a high SEER (Seasonal Energy Efficiency Ratio) rating. This means it consumes less energy while delivering powerful cooling and heating output, making it an environmentally friendly choice that also reduces utility bills. The unit is equipped with inverter technology, which allows the compressor to adjust its speed based on the cooling needs of the spaces, leading to quieter operation and increased energy savings.

The ASU18T indoor units feature a sleek and modern design that seamlessly integrates into various interior aesthetics. They are equipped with advanced air filtration systems to ensure clean and healthy air is circulated within the rooms. The filters capture dust, allergens, and other pollutants, enhancing indoor air quality, an essential aspect for families and individuals with respiratory issues.

An important characteristic of the Fujitsu AOU36T system is its ultra-quiet operation. The outdoor unit is designed to minimize noise levels, while the indoor units also operate quietly, ensuring that the comfort is not disrupted by loud mechanical sounds. This feature makes it perfect for bedrooms, offices, and other noise-sensitive environments.

The multi-split system also includes smart technology features, allowing users to control the temperature and settings remotely using a smartphone app. This provides convenience and flexibility, enabling adjustments based on individual preferences and schedules.

Moreover, the AOU36T supports heating functionality, making it a reliable choice for year-round climate control. It can effectively manage heating needs even in colder temperatures, providing warmth and comfort during winter months.

In conclusion, the Fujitsu AOU36T multi-split air conditioning system with ASU18T indoor units offers a comprehensive solution for effective climate control in multiple rooms. Its combination of energy efficiency, advanced technology, quiet operation, and smart features make it an excellent choice for those seeking comfort without compromising on performance or environmental responsibility.
Top Page Image Contents