Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call qualified service technician or gas supplier. Force or attempted repair may result in a fire or explosion.
Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and replace any part of the control system and any gas control component which has been under water.
LIGHTING INSTRUCTIONS:
1.Read the aforementioned safety information.
2.Make sure manual shutoff valve is fully open.
3.Push in gas control knob slightly and turn clockwise 
to the OFF position.
4.Wait five minutes to clear any gas. Then smell for gas, including near the floor. If you smell gas, follow the safety information on the front page. If you don’t smell gas, go to the next step.
5.Push in and turn gas control knob counterclockwise 
to IGN PILOT. This will light the pilot. The pilot can be seen through the glass panel. If needed, keep pressing and turning the control knob counterclockwise until the
pilot lights.
| 6 | 7 |
5 |
| |
| 1 | |
|
| |
4 |
| 2 |
|
| |
| 3 |
|
NO
PILOT
IGN
OFF
NOTE : If pilot does not stay lit, refer to troubleshooting Section XII. Also,
contact a qualified service person, or gas supplier for repairs. Until repairs are
made, light pilot with match. To light pilot with match, see the following manual
lighting instructions.
6.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob.
Page 14