13.Perform steps 1 through 6 (see page 16).
14.Place fine grade sandpaper (600 grit) on flat surface. Sand rotor lightly in “Figure 8” motion four times (see Figure 30).
15.Reinstall insert and rotor.
16.Perform steps 10 through 12 (see page 16).
SPECIFICATIONS
Gap Adjusting Screw
.003"/.004"
Blade 
Rotor
Gap Adjusting Screw
Figure 29 - Gap Adjusting Screw Locations
Sandpaper
Figure 30 - Sanding Rotor
Model Size | 35 | 100 | 150 |
Output Rating (Btu/Hr) | 35,000 | 98,000 | 150,000 |
Fuel | Use Only Kerosene or No. 1 Fuel Oil | ||
Fuel Tank Capacity (U.S. Gal./Liters) | 3/11.3 | 9/34 | 13.5/51 |
Fuel Consumption (Gal. Per Hr/ |
|
|
|
Liters Per Hr) | .26/.98 | .74/2.80 | 1.12/4.24 |
Nozzle Spray Angle | 50° | 60° | 60° |
Nozzle Spray Pattern | Solid Cone (All Models) |
| |
Electric Requirements | 120 V/60 HZ (Same All Models) |
| |
Amperage (Normal Run) | 1.7 | 3.2 | 4.4 |
Motor RPM | 1725 | 3450 | 3450 |
Hot Air Output (CFM) | 165 | 481 | 500 |
17
100577