ASSEMBLY
(For 100 and 150 Models Only)
6
These models are furnished with wheels and a front handle. Wheels, front handle, and the mounting hardware is found in the shipping carton.
Tools Needed
•Medium Phillips Screwdriver
•3/8" Open or Adjustable Wrench
•Hammer
1.Slide axle through wheel support frame. Install wheels on axle. IMPORTANT: Place extended hub of wheel toward wheel support frame.
2.Place cap nuts on axle ends. Gently tap with hammer to secure.
3.Place heater on wheel support frame assembly. Make sure air inlet end of heater is over wheels.
4.Place handle on top of fuel tank flange. Insert screws through handle, fuel tank flange and wheel support frame. Attach nut finger tight after each screw is inserted.
5.Tighten all nuts firmly.
Handle
Screw
Hot Air
Outlet
Fuel
Cap
Air Inlet
Fuel
Tank
Flange
Wheel
Support
Frame
Wheel | Nut |
| |
|
| ||
Cap Nut |
| Extended | |
Axle | Hub | ||
|
Figure 4 - Wheel and Handle Assembly, 100/150 Models Only
100577