Homelite HHC100A, HHC35A, HHC150A owner manual Pump Rotor, Removing Nozzle, 100/150 Models

12.Attach burner head to combustion chamber.

13.Install spark plug in burner head.

14.Attach spark plug cable to spark plug.

15.Attach fuel and airline hoses to burner head.

16.Replace fan (see page 12).

17.Replace fan guard and upper shell.

Pump Rotor

(Procedure if rotor is binding)

1.Remove upper shell (see page 12).

2.Remove filter end cover screws using 5/16" nut-driver.

3.Remove filter end cover and air filters.

4.Remove pump plate screws using 5/16" nut-driver.

5.Remove pump plate.

6.Remove rotor, insert, and blades.

7.Check for debris in pump. If debris is found, blow out with compressed air.

8.Install insert and rotor.

9.Check gap on rotor. Adjust to

.003"/.004" (.076-.101 mm) if needed (see Figure 29).

Note: Rotate Rotor one full turn to insure the gap is .003"/.004" (.076-.101

mm)at tightest position. Adjust if needed.

10.Install blades, pump plate, air filters, and filter end cover.

11.Replace fan guard and upper shell.

12.Adjust pump pressure (see page 13).

Note: If rotor is still binding, proceed as follows.

Continued

16

Nozzle

Face Nozzle

Seal

Nozzle

Burner

Head

Fuel Line

Air Line Fitting

Fitting

Figure 26 - Removing Nozzle, 100/150 Models

Blade

Air Intake

Pump Filter

Plate

Filter End

Cover

Fan Guard

	Insert
50 ROTOR	Rotor
	PFA/P 056
	Air Output
	Filter

Figure 27 - Rotor Location, 35 Model

Air Intake

Blade Pump Filter

Plate

Filter End

Cover

Fan Guard

Insert

Rotor

100 ROTOR-Domestic	PFA/P 059A
	Air Output
	Filter

Figure 28 - Rotor Location, 100/150 Models

100577