GE Concord 4 manual Phone Communication Test

Device Test Procedure Touchpad Result(s)

Touchpad	Trip a:			•	Touchpad Panic POLICE OK
	Police panic alarm,			•	Touchpad Panic FIRE OK
	Fire panic alarm, and
	Auxiliary panic alarm.			•	Touchpad Panic AUXILIARY OK
				•	POLICE PANIC OK
				•	FIRE PANIC OK
				•	AUXILIARY PANIC OK
Wireless Touchpad	Press the Bypass key.			•	Zones nn OK
				•	TOUCHPAD nn OK
Keychain Touchpad	Press and hold the Lock	and Unlock	buttons	•	Zones nn OK
	simultaneously for 3 seconds.			•	TOUCHPAD nn OK
	Press and hold the Star	and Light	buttons	•	Touchpad Panic AUXILIARY OK
	simultaneously for 3 seconds.			•	AUXILIARY PANIC OK
Panic button	Press and hold the appropriate panic button(s) for 3			•	Zones nn OK
	full seconds.			•	SENSOR nn OK
Door/window sensor	Open the secured door or window.			•	Zones nn OK
				•	SENSOR nn OK
Smoke detector	Press and hold the test button until the system sounds			•	Zones nn OK
	transmission beeps.			•	SENSOR nn OK
Motion detector	Avoid the motion detector view for 5 minutes, then			•	Zones nn OK
	enter its view.			•	SENSOR nn OK
Rate-of-Rise Heat Detec- Rub your hands together until warm, then place one				•	Zones nn OK
tor (Not UL investigated)	hand on the detector for 30 seconds.			•	SENSOR nn OK
Shock sensor	Tap the glass twice, away from the sensor. Wait at			•	Zones nn OK
(Not UL investigated)	least 30 seconds before testing again.			•	SENSOR nn OK
Phone Interface and	Activate a Police panic by accessing the system using			•	POLICE PANIC OK
Voice Module	the phone and pressing * + * + * + * + * + *.
Glass guard sensor	Tap the glass 3 or 4 inches from the sensor.			•	Zones nn OK
(Not UL investigated)				•	SENSOR nn OK
Freeze sensor	Apply an ice cube wrapped in plastic to the sensor. Do			•	Zones nn OK
(Not UL investigated)	not allow the sensor to get wet.			•	SENSOR nn OK

•If you need more time to complete testing, restart the timer by pressing 8 + CODE + 3.

•Check to see that all sensors have been tested by pressing *. Touchpads display a list of untested sensors.

•You will know that you have finished testing when touchpads display, “SENSOR TEST OK” or “ZONES ALL TESTED.”

4.Disarm to Level 1—Off to exit Test Mode.

Phone Communication Test

The purpose of this test is to verify communication between the central monitoring station and your system.

Most phone tests take only a few minutes, however, your system will try for up to 15 minutes to establish a connection if necessary.

38 Concord 4 Series Security Systems