Louisville Tin and Stove W505F W256F, W506, W502F W255F, W351F Model WFF81-COPTIONAL FAN KIT, Step

MODEL WFF81-COPTIONAL FAN KIT

INSTALLATION INSTRUCTIONS

NOTE: This fan kit is to be installed after installation of wall furnace and with the wall furnace front panel in place.

STEP 1.	This appliance, when installed, must be electrically grounded in accordance with local codes, or in
	the absence of local codes, with the latest edition of the National Electric Code, ANSI/NFPA
	No. 70. In Canada, see the current Canadian Electrical Code CSA C22.1.
STEP 2.	Set fan kit on top of the wall furnace front panel. Using the back top edge of the fan kit cabinet
	as a guide, mark a horizontal line across the wall. Mark a small vertical line which aligns with the
	slot located toward the rear of the fan kit casing.
STEP 3.	Using the four one inch screws provided, secure the wall mounting bracket to wall 1/8” below the
	horizontal line. Fan attachment bracket must be up and threaded nut sert aligned with the small
	vertical line. Note: Anchors (not provided) may be required.
STEP 4.	Remove junction box and connect 115v power supply in accordance with the wiring diagram.
	Replace junction box.
STEP 5.	Set fan kit on top of wall furnace front panel. Slot should align with the nut sert. Secure fan kit
	to wall mounting bracket with thumb screw provided.

Thumb

Screw

Wiring

Threaded Nut	Slot	Diagram
Sert
Fan Attachment
Bracket

Wall Mounting

Bracket

One Inch

Screw (4)

Junction

Box

Fan

Kit

Wall Furnace

Front Panel

Page 13