Accessing Other Panels (cont’d)
NOTES:
When performing any of the arming commands, if there are faults in any of the partitions, none of the partitions will arm. These faults must be corrected or bypassed before attempting to arm.
When performing either a STAY or INSTANT arm command the system always arm in mode 1 (see page 36 Arming Perimeter Only for a detailed explanation of the STAY arming modes.
The user cannot execute another panel linking mode. To execute another panel linking mode or to access a different remote panel, the user must first exit this mode (return to the original control panel).
Multi-Panel View Mode
To access the
1. Enter your security code + | # | + |
2.The keypad displays the following:
8
+
7
ALLPANEL | 1 2 3 4 5 6 7 8 |
STATUS | x x x x x x x x |
|
|
where “12345678” are the panel id #s and “xxxxxxxx” is the overall status of each panel. Possible status indications include:
A = Armed Away | S = Armed Stay | M = Armed Maximum |
I = Armed Instant | R = Ready | N = Not Ready |
B = Bypassed/Ready | ✴ = Alarm | T = Trouble |
F = Fire Alarm | P = AC Power Failure | L = Low System Battery |
C = Comm Fail |
|
|
NOTE: See the table that follows for priority of displays.
Use the following keys to perform a function in the
Press
Press
Press
Press
Press
1
2
3
4
7
to attempt to disarm all partitions on all panels.
to attempt to arm AWAY all partitions on all panels.
to attempt to arm STAY all partitions on all panels.
to attempt to arm MAXIMUM all partitions on all panels.
to attempt to arm INSTANT all partitions on all panels.
– 29 –