SECURING THE PREMISES
Arming the System
Arming in Stay Mode
Use this mode when you are staying home, but expect someone to use the entrance door later. Close all protected perimeter windows and doors before arming. The green Ready indicator on the control should be lit if the system is ready to be armed. When armed in STAY mode, the system will sound an alarm if a protected door or window is opened, but you may otherwise move freely throughout the premises. Late arrivals can enter through the designated entrance door without causing an alarm, but they must disarm the system within the entry delay period or an alarm will occur. If Quick Arm was programmed by the installer, you do not need to enter the security code to arm the system. The security code must always be used to disarm the system, however.
The Babysitter Code and Installer Code cannot disarm the system unless it was used to arm the system. In addition, if the system is armed by pressing via
Ready To Arm
|
|
|
| 72 |
|
| Zones |
| Automation |
Arm Away | Arm Stay | Message |
| Phone |
Delay | 10:18 AM June 8, 2010 |
| More | |
|
|
|
| |
| Ready To Arm |
|
| |
Arm the system in Stay mode | 1 | 2 | 3 | |
|
| |||
Enter Code: | 4 | 5 | 6 | |
|
| |||
|
| 7 | 8 | 9 |
| Cancel | Clear | 0 |
|
|
|
|
| |
1.Select the Arm Stay icon, the system beeps once and displays a keypad.
2.Enter a valid User Code.
OR
If Quick Arm has been enabled, select the “Quick Arm” icon.
The system beeps three times and announces “Armed Stay Exit Now”. The exit delay screen is displayed. If programmed the display counts down the time remaining in the exit delay.
Note: If a valid user code is not entered or the Confirm icon has not been selected within 10 seconds, the system returns to the “home” screen and it will not be armed.
– 19 –