Honeywell L5100 manual Automation, Programming Rules

USER FUNCTIONS

Automation

General Information

Automation is used to program triggers, home automation features, send Follow-Me or E- mail messages of system events or program home automation features (Z-Wave) including Rules and Scenes (if Z-Wave communications have been enabled). Up to 40 rules can be programmed. Rules 1 through 20 are used for Triggers, Z-Wave Scenes and Follow-Me Messages. Rules 21 through 40 are used to trigger Z-Wave Scenes and for E-mail notification and are only accessible through TotalConnect Service. Check with your Installer to see which options are available to you.

Note: Switches, Thermostats, Locks, Tools, and Scenes options will only appear when Z-wave has been enabled.

Rules

The following options are programmed in this section:

Programming Field	Action
Rule 1 - 20:	Select Rule 1 -20
	Note: Rules 21-40 are only accessible through TotalConnect Service.
Name:	Name the device
Type:	Select the output type
Action:	Select the action required for the device
Start Zone Type:	Select Zone Type to start event*
OR
Zone Type Fault:
Stop Zone Type:	Select Zone Type to stop event*
OR
Zone Type Restore:
Start System Operation:	Select System Operation to start event*
OR
System Operation 1
Stop System Operation:	Select System Operation to stop event*
OR
System Operation 2
Zone Number Operation:	Select Zone Number to trigger event upon fault, trouble or alarm as selected.

* The displayed field is dependant upon the selection made

Programming Rules

Ready To Arm

72

ZonesAutomation

1.With the system in the disarmed state, select the “Automation” icon from the Home Screen. The system displays the Keypad screen.

Arm Away	Arm Stay	Message	Phone
Delay	10:18 AM June 8, 2010		More

5100-100-004-V0

– 47 –