Kenmore 153.332562 Temperature Regulation, Hotter Water can Scald Water heatersare intendedto

Operating Instructions (cont'd)

Temperature Regulation

Due to the nature of the typical gas water heater, the water tem-

{_oerature in certain situations may vary up to 30°F higher or wer at the point of use such as, bathtubs, showers, sink, etc.

This means that when the temperature adjustment dial is set at the mark approximating 1200F, the actual water temperature at any hot water tap could be as high as 150°F or as low as 90*E

Any water heater's intended purpose is to heat water. Hot water is needed for cleaning (bodies, dishes, clothing). Hot water will present a scald hazard. Depending on the time element, and the

people involved (normaladults, children, toddlers, elderly, infirm, etc.) scalding may occur at different temperatures.

A, WARNING

HOTTER WATER CAN SCALD: Water heatersare intendedto

producehot water. Water heated to a temperature which will satisfydotheswashing,dishwashing,and other sanitizingneeds can scaldand permanentlyinjureyou upon contact.Some pen- pie are more likelyto be permanently injuredbyhot water than other_ These includethe elderly,children,the infirm, or physica_ ly/mantelly handicappedIf. anyoneusinghot water in your home fitsinto oneof thesegroupsor if there isa localcodeor state law requiringa certaintemperatom water at the hot water _ then _u musttake specialprecautionLIn additionto usingthe lowest _esible temperature settingthat satisfiesyour hot water needs, Lmeanssuchas a mixing valve,shouldbe usedat the hot water taps usedby these people or at the water heater. Mixingvalves are availableat plumbingsupplyor hardwarestore_ Followman- ufacturers instructions for installation of the valves. Before

changing the factory setting on the thermostat, read the "Temperature Regulation"sectionin this manual.

AWARNING

Never allow smallchildren to usea hot water _ or to draw their own bath water. Never leavea childor handicappedper- sonunattended in a bathtub or shower.

2

The thermostat of this water heater has been factory set at its lowest position, to reduce the risk of scald injury. It is adjustable and must be reset to the desired temperature setting. The mark

(•)HOT indicative of approximately 120°F is the preferred starting point. Some states have a requirement for a lower set- ting. lfyou need hotter water, follow directions for temperature adjustment, but beware of the warnings in this section.

Turn the water temperature dial clockwise (_--'_) to decrease

the temperature, or counterclockwise (_"_) to increase the

temperature.

PILOT LIGHTING-Set here before attempting to light pilot.

•HOT- Is a thermostat setting of approximately 120°F, which will supply hot water at the

most economical temperatures. The

temperature adjustment knob can be turned lower than "HOT" if desired.

A-Is a thermostat setting of approximately 130°E

B-Is a thermostat setting of approximately 140°E

C-Is a thermostat setting of approximately 150°E

VERYHOT- Is a thermostat setting of 160°F. It is recommended that the dial be set lower

whenever possible.

NOTE: Water temperature range of 1200--1400Frecom- mended by most dishwasher manufacturers.

AWARNING[ Shouldoverheatingoccuror the gassupplyfail to shut off,] I tom "OFF" the manualgascontrolvalveto theappliance. ]

19