Kenmore 153.331492, 153.331592 Tank Sediment Cleaning, Vent System Inspection, Burner Inspection

Page 25

Tank (Sediment) Cleaning

Sediment build-up on the tank bottom may create varying amount of noise, and if left in the tank will cause permanent tank failure. In some water areas, you may not be able to drain all sediment deposits by simply draining the tank. In these cases, Mag-Erad (part no. 23600) can be used to help remove the sediment deposits. This may be ordered from the Sears Service Center. For ordering, refer to the "Parts Order List" section.

Vent System Inspection

Ca_on Monoxide and Fire Hazard

,Fiue gases may escape if vent pipe is not connected

*Be alert for obs.tructed, sooted or

deteriorated vent system to avoid sedous injury or death.

Do not store corrosive chemicals in vicinity of water heater.

Chemical corrosion of flue and vent

system can cause serious injury or death

Breathing carbon monoxide can cause brain damage or death. A(ways read and understand instruction manual

At least once a year, a visual inspection should be made of the venting system. You should look for:

• Obstructions which could cause improper venting. The combustion and ventilation air flow must not be obstructed.

Damage or deterioration which could cause improper venting or leakage of combustion products.

Rusted flakes around top of water heater.

Be sure the vent piping is properly connected to prevent escape of dangerous flue gasses which could cause deadly asphyxiation.

Obstructions and deteriorated vent systems may present serious health risk or asphyxiation.

Chemical vapor corrosion of the flue and vent system may occur if air for combustion contains certain chemical vapors. Spray can

propellants, cleaning solvents, refrigerator and air conditioner refrigerants, swimming pool chemicals, calcium and sodium chloride, waxes, bleach and process chemicals are typical compounds which are potentially corrosive.

If when inspecting the vent system you find sooting or deterioration, something is wrong. Call the local gas supplier to correct the problem and clean or replace the flue and venting before resuming operation of the water heater.

Burner Inspection

Flood damage to a water heater may not be readily visible or immediately detectable. However, over a period of time a flooded water heater will create dangerous conditions which can cause

DEATH, SERIOUS BODILY INJURY, OR PROPERTY DAMAGE. Contact a Sears Service Center to replace a flooded water heater. Do not attempt to repair the unit! tt must be replaced!

At least once a year, a visual inspection should be made of the main burner and pilot burner. See Figure 29.

You should check for sooting. Soot is not normal and will impair proper combustion.

Soot build-up indicates a problem that requires correction before further use. Turn "OFF" gas to water heater and leave off until repairs are made, because failure to correct the cause of the sooting can result in a fire causing death, serious injury, or property damage.

FIGURE 29.

Burner Cleaning

Fire or Explosion Hazard

Failure to properly reseal the combustion chamber will disable the flammable vapor ignition resistance feature of this water heater, which could result in death or serious

injury. Contact your local Sears Service Center for assistance.

installing, using or servicing Read instruction manual before water heater.

In the event your burner needs cleaning, follow these instructions:

If inspection of the burner shows that cleaning is required, turn the

gas control knob counterclockwise ( _ ) to the "OFF" position, depressing slightly.

NOTE: The knob cannot be turned from "PILOT" to "OFF" unless

knob is depressed slightly. DO NOT FORCE.

The burner needs to be removed for cleaning. Call the Sears Service Center to remove and clean the burner and correct the problem that required the burner to be cleaned.

25

Image 25
Contents =iI=1,Ctd,,,it= 153.331492 Gallon 153.331592Important Definitions Read and follow water heater warnings and instructionsFire or Explosion Harzard Improper installation and use may result in property damageFire Hazard GAS Supply Troubleshootingguide Year Limited Warranty on Water Heater Important Information About This Water Heater Excessive Weight HazardMaterials Needed Vent Pipe Inner Door Gas Control GET to Know Your Water Heater GAS ModelsInstallation Checklist Manualgas SHUT-OFFVALVE Removing the Old Water HeaterCSite Location Location RequirementsCarbon Monoxide Poisoning Hazard Fire or Explosion HazardInsulation Blankets Clearances and AccessibilityProperty Damage Hazard Breathing Hazard Carbon Monoxide GasGas Requirements Filling the Water HeaterGas Piping Explosion HazardGas Pressure Gas Pressure TestingUnconfined Space Carbon Monoxide WarningAll Air from Inside the Building Confined SpaceLouvers and Grilles All Air from OutdoorsVent Connectors Draft Hood InstallationVent Pipe Size Vent Pipe SystemVertical Exhaust Gas Vent Chimney ConnectionTvALvE Piping InstallationTemperature & Pressure Relief Valve Temperature and Pressure Relief ValveClosed System/Thermal Expansion Explosion HarzardWhat to do if YOU Smell GAS Lighting InstructionsChecking the Draft Water Temperature RegulationBurner Flames Emergency Shut DownGascontroutemperatureknob Vent System Inspection Tank Sediment CleaningBurner Inspection Caon Monoxide and Fire HazardHousekeeping Temperature-Pressure Relief Valve OperationAnode Rod Inspection Draining and FlushingService Full Assembly Electronic Control Module External Inspection & Cleaning Base-Ring Filter Replacement PartsRemoving the Burner from the Manifold Burner Assembly Removing the Manifold/Burner AssemblyExplosion Hazard Cleaning the Combustion Chamber and Flame-arrestorPiezoelectric Igniter System Expansion Tank Sizing Chart Expansion Tank SpecificationsStart Up Conditions Strange SoundsOperational Conditions Page Problemled Status Problem Page Page Page Page Page

153.331492, 153.331592 specifications

The Kenmore 153.331592 and 153.331492 are two innovative models in a series of versatile and efficient appliances designed to enhance everyday living. These products cater to a wide range of household needs, making them not only practical but also integral to modern home technology.

One of the standout features of the Kenmore 153.331592 is its energy efficiency. Designed with advanced technology, this model consumes less energy while providing robust performance. This is particularly important for environmentally conscious consumers looking to reduce their carbon footprint without compromising on effectiveness. The appliance utilizes smart energy management systems that optimize power use, ensuring that households can enjoy high performance with minimal energy costs.

On the other hand, the Kenmore 153.331492 offers impressive capacity, making it ideal for larger families or those who frequently entertain guests. This model is designed to accommodate substantial loads, whether it be laundry, cooking, or storage, making it a perfect fit for busy households. Additionally, its spacious design allows for easy organization, ensuring that items can be stored efficiently without clutter.

Both models incorporate advanced technology, including intuitive digital controls. These controls allow users to easily set preferences and monitor their appliance's operation through user-friendly interfaces. Smart connectivity features are also integrated into both models, allowing for remote management via smartphone apps. Users can adjust settings, receive alerts, and even perform diagnostics from the convenience of their phones, highlighting Kenmore's commitment to convenience and ease of use.

In terms of build quality, both models exhibit durable construction with high-quality materials designed to withstand the rigors of daily use. The sleek and modern design enhances their aesthetic appeal, making them suitable for any kitchen or laundry room decor.

Additionally, safety features such as auto shut-off, child locks, and overload protection are included in both models, ensuring that they operate smoothly without unnecessary risks.

In conclusion, the Kenmore 153.331592 and 153.331492 stand out for their blend of efficiency, capacity, and smart technology integration. These models present a compelling choice for those seeking reliable appliances that cater to both traditional and modern lifestyles. With a focus on energy conservation, user-friendly interfaces, and durable build quality, Kenmore continues to solidify its reputation as a leader in home appliance innovation.