r. WARNING
Electrical Shock Hazard
Do not operate the cleaner without the motor safety filter. Be sure the fil- ter is properly installed to prevent motor failure and/or electrical shock.
Always unplug power cord from elec-
trical outlet before performing any service on vacuum,
SECONDARY FILTER
FOAM
Check secondaryfilter frequently and clean
when dirty.
Remove the dust bin as outlined in the
DUST BIN CLEANING section.
Remove secondary filter from vacuum cleaner.
EXHAUST FILTER
HEPA
The exhaust filter must be replaced when
dirty. It should be replaced regularly
depending on use conditions,
The filter CANNOT be washed as it will
lose its dust trapping ability.
NOTE: See PARTS AND FEATURES for the exhaust filter number.
Press release tab
on filter cartridge and pull out of canister. (Cover not shown for
clarity).
Remove filter
from cartridge by
pushing out through the slot in
the cartidge.
TO REPLACE FILTER
Slide new filter into
cartridge so that the foam side will face towards the canister, as shown.
Wash the secondary filter in warm soapy water, rinse and dry thoroughlyby squeez- ing the filter in your hand and lettingit air dry.
DO NOT wash in the dishwasher.
DO NOT install damp.
Replace dry secondaryfilter. Ensure filter is properlyinstalled over filter opening.
Replace the dust bin as outined in the DUST BIN CLEANING section.
should be placed into the
cartridgeThe filter so that the "A"
symbolsalign.
Replace the exhaust filter
catddge by plac-
ing tabs in slots and pushingdown
until cartridge snaps into place.
16