TO REMOVE BELT
\ | 1. Turn Power- |
| Mate® upside |
| down. |
| 2. Unscrew the |
| two (2) Power- |
| Mate ® cover |
| screws. |
3. Turn Power- |
|
Mate® right side |
|
up. Press handle |
|
release pedal and |
|
lower the swivel. |
|
Uft rear latches up. |
|
4. TO remove cover, grasp the sides and
pull out, then up.
TO REPLACE BELT
1.Install new belt over motor drive, then over brush sprocket.
Motor
Drive
NOTE: | See |
|
PARTS | AND | End Cap |
FEATURES |
| |
for the | belt |
|
number. |
|
2. Place agitator
assemblyback into Power-Mate® .
3.Reinstall agitator cover by lining up the front tabs and slots and rotat-
5.Depress tabs on rear of
agitator cover and rotate cover forward to release from the
Tabs
ing downward until the latches
snap into ===
place.
Agitator Cover
Agitator
base andCover remove.
6. Lift agitator assembly out and remove worn belt.
End Cap
4. Line up front of cover and base. Rest cover on
front edge of base as shown.
5. Rotate cover | \ |
back, Press |
|
cover firmly until |
|
side and rear |
|
tabs snap into |
|
place. Turn |
|
| |
upside down and |
|
replace two (2) |
|
cover screws. |
|
18