ADT Security Services Security System Bypassing Protection Zones, Using 6 Ê Bypass Key, 18 Ð

BYPASSING PROTECTION ZONES

Using the

ÊÊ 6 Ê BYPASS Key

All bypasses are removed when an OFF sequence (security code plus OFF) is performed.

TO BYPASS ZONES:

¥ Enter code.

This key is used when you want to arm your system with one or more zones intentionally unprotected. The system must be disarmed first.

1.Enter your security code and press the BYPASS [6] key.

2.Enter the zone number(s) for the zone(s) to be bypassed (e.g., 06, 10, 13, etc.).

Single digit zone numbers must be preceded by a zero (e.g. 05, 06).

3.When finished, the touchpad will momentarily display a "Bypass" message for each bypassed zone number. Wait for these zones to be displayed, to confirm their bypass.

4.Arm the system as usual.

Bypassed zones are unprotected and will not cause an alarm if violated while your system is armed.

TYPICAL MOMENTARY DISPLAYS	TYPICAL DISPLAYS AFTER ALL BYPASSED
OF BYPASSED ZONE(S)	ZONES HAVE BEEN DISPLAYED (PRIOR TO ARMING)

¥ Press BYPASS key.

¥ Enter zone Nos.

¥ Wait for bypassed zones

ÊÊto be displayed.

¥ Arm system as usual.

BYPASS 06

BE DROOM WINDOW

CUSTOM DISPLAY TOUCHPAD

DISARMED BYPASS RE ADY TO ARM

CUSTOM DISPLAY TOUCHPAD

Ê06	AC
	BYPASS

THE ÒREADYÓ INDICATOR WILL LIGHT TO SIGNIFY THAT THE SYSTEM IS READY TO ARM

AC

BYPASS

ENGLISH DISPLAY TOUCHPAD ENGLISH DISPLAY TOUCHPAD

To display bypassed zones prior to arming (see displays above, right), enter your security code and press the BYPASS [6] key. This will also bypass any open zones at that time (if ÒQuick BypassÓ is enabled Ð see following page).

Ð 18 Ð