ADT Security Services Security System, Security Manager 2000 user manual Exit Test Mode, 28 Ð

Page 28

TESTING THE SYSTEM

(CONTINUED)

Walk in front of any interior motion detectors (if used) and listen for three beeps. The identification of the detector should appear on the display when it is activated. The display will clear when no motion is detected. Note that if wireless motion detectors are used, there is a 3-minute delay between activations. This is to conserve battery life.

To test all smoke detectors, follow the manufacturer's instructions. The identification of each detector should appear on the display when each is activated.

If a problem is experienced with any protection point (no confirming sounds, no display),

CALL FOR SERVICE IMMEDIATELY.

When all protection points have been checked and are intact (closed), there should be no zone identification numbers displayed on the touchpad.

When testing is completed, exit the TEST mode by continuing with step 5.

OFF

5. ÊÊÊ ÊÊÊ ÊÊÊ ÊÊÊ + ÊÊÊ1 ÊÊ

ÊÊÊ(Security Code)

EXIT TEST MODE

Enter your security code and press the OFF key.

If the test mode is inadvertently left active, it automatically turns off after 4 hours.

Ð 28 Ð

Image 28

Contents Security System About This Manual Table of Contents System Overview General Partitioned SystemSystem Overview Single-Button Paging General Information ENTRY/EXIT DelaysPartition Exit Alarms ENTRY/EXIT DelaysCommon Zone Operation About the Touchpads About the Touchpads 10 ÐFunctions of the Touchpads 11 ÐCustom English Display Touchpad English Display Touchpad12 Ð Checking for Open Zones Using the Ready Key13 Ð Using 3 Ê Stay Key Arming Perimeter only With Entry Delay on14 Ð Instant Key Arming Perimeter only With Entry Delay OFF15 Ð Arming ALL Protection With Entry Delay on Using 2 Ê Êaway KeyUse this key when no one will be staying inside 16 ÐUsing 1 Ê Êoff Key Disarming and Silencing Alarms17 Ð Bypassing Protection Zones Using 6 Ê Bypass Key18 Ð Bypassing Protection Zones 19 ÐChime Mode Using 9 Ê Êchime KeyTo turn Chime Mode on To turn Chime Mode offFor Manually Activating Silent AND/OR Audible Alarms Using Panic KeysPanic Keys 21 ÐVerify this with your installer Manually Initiating a Fire Alarm22 Ð Enter Security Code then Press # + 7 + Device Number Using Device CommandsEnter Security Code then Press # + 8 + Device Number Paging Feature 24 ÐDuress Code Quick Arming Single-Button Security Codes25 Ð Security Codes Testing the System Using the Test KeyÊEnter the security code, then press Test key 27 ÐExit Test Mode 28 ÐTrouble Conditions Check and Battery Displays29 Ð Trouble Conditions COMM. FailureSystem LO BAT Modem CommTotal Power Failure Busy-Standby Disabled. Call for Service ImmediatelyOpen Circuit Long Rng TrblMaintaining Your System Maintaining Your System 33 ÐQuick Guide to System Functions 34 ÐSummary of AUDIBLE/VISUAL Notifications 35 ÐSummary of AUDIBLE/VISIBLE Notifications 36 ÐUL Notice This is a Grade a Residential System 37 ÐFederal Communications Commission FCC Part 68 Statement 38 ÐAvis 39 ÐLimitations of this Alarm System 40 ÐLimitations of this Alarm System 41 ÐLimited Warranty 42 ÐInstallation 43 ÐÀN7527-6V2Dä