ARMING PERIMETER ONLY (With Entry Delay ON)
Using the
ÊÊ 3 Ê STAY Key
BEFORE ARMING,
close all doors and windows (see CHECKING FOR OPEN ZONES on page 13).
ÊTHE STAY MODE ARMS ÊTHE PERIMETER, BUT ÊALLOWS USE OF THE ÊENTRY/EXIT DOOR.
ÊPERSONS WITHIN THE ÊPREMISES CAN MOVE ÊABOUT FREELY.
Ask your installer if this feature is programmed in your system. If so, place a check in this box. ÊÊÊÊ
Use this key when staying inside, but expect someone to use an entry/exit door later. It is also useful if you are leaving but someone is staying inside (or if you have pets which are moving throughout the premises.
1.Enter your security code and press the STAY [3] key. In some systems, pressing the ÒBÓ key on on the touchpad for 2 seconds will arm the system STAY (no code is required). The ÒBÓ key may or may not have been programmed for this. Check with your installer.
2.The touchpad beeps three times and displays the armed STAY message (see displays below). The red ARMED indicator also lights. Note that there is an exit delay in effect before arming actually takes place. See the note below.
3.After arming, an alarm sounds immediately if a protected perimeter window or non- entry/exit door is opened, but you may otherwise move freely within the premises.
Anyone entering later can enter through an entry/exit door without causing an alarm, but they must disarm the system within the entry delay period to avoid sounding an alarm.
Exit Delay Restart. If you wish to open the entry/exit door to let someone in after arming STAY, you can
Note: When you first arm in the STAY mode, ÒYou may exit now” will be displayed on a Custom Display Touchpad during the programmed exit delay. This delay is in effect even when arming STAY. When ÒYou may exit now Ó disappears, the system is fully armed.
TYPICAL DISPLAYS Ð ÒARMED STAYÓ
AC
STAY
ARME D ***STAY ***
YOU M AY E XIT NOW
ENGLISH DISPLAY TOUCHPAD | CUSTOM DISPLAY TOUCHPAD |