7HVWLQJWKH6\VWHP 7R%H&RQGXFWHG:HHNO\
The TEST key puts your system into the Test mode, which allows each protection point to be checked for proper operation.
• The touchpad sounds a single beep every 40 seconds as a reminder that the system is in the Test mode.
• Alarm messages are not sent to your Customer Care Center while Test mode is on.
1 Disarm the system and close all protected windows, | |||||
doors, etc. The READY indicator light should come | |||||
on if all zones are intact (i.e., all protected windows, | 6)%(=83%61 | ||||
doors, etc. are closed. |
| ||||
| + |
| then [0] (walk) |
| |
2. | 5 | = (- | |||
(Security Code) |
| TEST | |||
| = ;%0/ | ||||
The Dial test (option “1”) is intended for the installer |
| ||||
| |||||
and should not be used unless directed to do so by |
| ||||
your Customer Care Representative. |
| ||||
3. Listen. The external sounder should sound for 1 |
| ||||
| |||||
second and then turn off. If the sounder does not | |||||
sound, CALL FOR SERVICE. | 463+6)77 | ||||
|
|
|
|
| |
4.Fault zones. Open each protected door and window in turn and listen for three beeps from the touchpad. Identification (zone number or zone description) of each faulted protection point should appear on the display. The display clears when the door or window is closed.
5.Walk in front of any interior motion detectors (if used) and listen for three beeps. The identification of the detector should appear on the display when it is activated. The display clears when no motion is detected.
Note that if wireless motion detectors are used, there is a
6.Test all smoke detectors, following the manufacturer's instructions. The identification of each detector should appear on the display when each is activated. If a problem is experienced with any protection point (no confirming sounds, no display), call for service immediately.
When all protection points have been checked and are intact (closed), there should be no zone identification numbers displayed on the touchpad.
7. Exit test mode:
+[ 1 ]
(Security Code)
If the test mode is inadvertently left active, it automatically turns off after 4 hours.
– 36 –