ADT Security Services 3000 manual Rcvr Jam, Or Check

7URXEOH&RQGLWLRQV&RQWLQXHG

Other Trouble

Displays

*Any “beeping” that accompanies a trouble display can be stopped by depressing any key on the touchpad or by entering an OFF sequence (code + OFF)

**Not all systems use wireless sensors.

Words or letters in parentheses ( ) are those that are displayed on English Display touchpads.

COMM. FAILURE	Indicates that a failure has occurred in
(or FC)	the telephone communication portion of
	your system.
	CALL FOR SERVICE.
SYSTEM LO BAT	Indicates that a low system battery
(or BAT with no	condition exists. Display is
zone No.)	accompanied by "beeping"* at the
	touchpad. If this condition persists for
	more than one day (with AC present),
	CALL FOR SERVICE.
LO BAT	Indicates that there is a low battery
+ zone descriptor	condition in the wireless transmitter**
(or BAT with	number displayed (00 is RF keypad).
zone No.)	Accompanied by a single "beep"* (once
	every 40 seconds) at the touchpad.
	Either replace the battery yourself, or
	CALL FOR SERVICE. If the battery is
	not replaced within 30 days, a CHECK
	display may occur.
Rcvr Jam	Wireless part of the system is experiencing
(or CHECK 90)	RF interference which may impede
	reception from wireless sensors.**
MODEM COMM	Indicates that the control is on-line with
(or CC)	the Customer Care Center's remote
	computer.
	The control will not operate while on-line.
	Wait a few minutes — the display should
	disappear.
BELL FAILURE	Indicates that the wiring connection to
(or CHECK 70)	the external sounder is at fault (open or
	shorted). Accompanied by “beeping” at
	the touchpad. CALL FOR SERVICE.

– 38 –