Harman Stove Company 1-90-79700 7Appliance Set-Up, Outside Air Attachment, Leveling the Appliance

Page 22

Oakleaf Woodburning Stove

7Appliance Set-Up

A. Outside Air Attachment

Parts and Supplies Needed: 1 piece of metal flexible pipe, 4" X needed length. 1 Rodent Screen, and aluminum tape. Plus, a trim ring for finishing around the pipe on the inside wall.

1.Determine an appropriate hole location, through the wall. Be sure there are no studs or other supporting members. Also ensure there are no electrical wires or plumbing contained within the wall.

2.Make the hole through the exterior wall using a hole saw or reciprocating saw. You'll want the hole to be just slightly larger than the metal flex pipe.

3.Attach the rodent screen to one end of the flex pipe, and insert it through the wall until the back of the screen cover is against the outside surface.

4.Hold the flex pipe in place to make an accurate determination of the length needed. Cut the flex pipe to length.

5.Slide the trim ring onto the flex for the inside wall portion.

6.Slide the other end of the metal intake flex pipe into the stub on the rear of the Oakleaf and secure it with aluminum tape. This air intake will supply outside air for the secondary combustion within the FireDome.

7.Secure the trim ring in place for finishing the inside wall area.

8.Seal around the rodent screen on the exterior wall, using silicone caulking.

B. Leveling the Appliance

To adjust the leveling bolts, you must first loosen the locking nut. Turn the leveling bolt to the desired position, and tighten the locking nut against the cast iron leg.

C. Optional Cooking Grill

The optional cooking grill #1-00-08121 installs easily in the top load opening of the Oakleaf.

The grill handle (B) fits in the slots (C) on each side. To remove the handle, lower and turn.

When installed, the grill hangs in the opening by the hooks (A).

When grilling, you'll want to keep the fire size small and the bypass damper in the open position. Depending on the grilling being done, you may get grease dripping on the glass causing it to become dirty and obstructed. When you burn your next hot fire, the glass will likely clean itself.

CAUTION

Never draw outside combustion air from:

Wall, floor or ceiling cavity.

Enclosed space such as an attic or garage

Outside Air

Attachment

A

B

A

C

C

A

22 Dry Seasoned Wood Only!

3-90-798

Save These Instructions

Image 22
Contents Installation and Operation Do Not DiscardOakleaf Woodburning Stove Table of Contents 1Listing and Code Approvals This appliance is also approved for installation in a shopMobile Home Approved If the alarm sounds 2Special Warnings and Notes3Getting Started Design, Installation & Location ConsiderationsFire Safety Appliance LocationComponent Locations Flue Direction ConversionPre- Use Check List Fire Risk4Dimensions & Clearances Appliance DimensionsClearances To Combustibles 17 / 432 mm 14 / 356 mm 26.75 / 679 mm *17.5 / 444 mmClearance to Combustibles Corner Installation Floor Protection Floor Protection RequirementsFloor Protection Requirements RequirementsDraft Chimney ConnectorsChimneys and Venting Wall Pass-thrusChimney 3-foot, 2-foot, 10 foot ruleVenting to a Masonry Chimney Installing to a Prefabricated ChimneyExisting Masonry Chimneys Venting to a Masonry Fireplace ChimneyAttic Factory-BuiltShield Metal ChimneyAirtight insulated Clean- out Oakleaf Woodburning Stove Full Relining Fireplace Conversion Freestanding Appliance Chimney Breach Fireplace Conversion with Combustible Wall Mobile Home Installation 6Mobile HomeLeveling the Appliance 7Appliance Set-UpOutside Air Attachment Optional Cooking GrillOptional Rear-vent Rear Shield Optional Blower InstallationOptional Bottom Heat Shield 8Operating Instructions Fuel SpecificationsAlways wear fire retardant gloves When operating the stove General Operating InformationDoors Or change the configuration of this grate systemCombustion Process GratesBefore Your First Fire User ControlsBuilding and Maintaining a Fire Oakleaf Woodburning Stove Seasonal cleaning Service & MaintenanceCreosote- Formation and Need For Removal By User Wear Leather Gloves To Prevent Skin Burns General Maintenance ProceduresAsh Removal Door GlassFirebox Blower- If installedChimney Oakleaf Optional Blower Kit #1-00-797032 Wiring Diagram 10Reference MaterialsService parts Part number list on followingStocked At depotStocked at depot Grams Per Hour 50% 60% 70% 80% 90% 100%Limited Lifetime Warranty Hearth & Home Technologies IncWarranty Conditions This warranty is void ifService & Maintenance Log Page Signature of Boxer Proudly Printed On 100% Recycled Paper